General Electric IM-6D Instrucciones Para Instalación página 30

ICEMAKER INSTALLATION INSTRUCTIONS S
of the refrigerator—
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
To reduce the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
PREPARE FOR INSTALLATION
1
Remove the storage
by pulling it out to the stop
position and lifting
it up and out.
NOTE: After removing the
basket, push the extension
arms back into the freezer
compartment.
Remove the chiller shelf
pulling it straight out.
Remove the ice bucket by
pulling it out and lifting it
up and out.
Remove the center vertical
models) by lifting it and
rotating its bottom to the
right.
30
Installation Instructions
L M N Q R S T U V
Pliers Sharp knife
or W
PREPARE FOR INSTALLATION
1
(CONT.)
Remove all freezer baskets for greater
accessibility to the rear of
the freezer.
Remove and discard the
large white plug from the
rear freezer wall. Pull out
the gray insulation plug
and remove any debris.
Remove the outlet
cover with a flat-blade
screwdriver.
INSTALL FILL TUBE
2
Slide the fill tube
water tube inlet
Go to the back of the refrigerator.
remove the label covering the
hole. Pull out the insulation plug
and any debris.
On the tube side of the water
tube inlet
adhesive backing. Remove the
adhesive backing and slide the
tube into the hole near the top at
the back of the refrigerator. Firmly
press on the inlet to secure it to
the refrigerator.
SET POWER SWITCH TO OFF
3
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
Remove side wall
plug
plug buttons or leave
screws in place
Rear wall
plug button
Outlet
cover
19
20
49-60704-2