Installation; Installation Conditions - Polytropic PAC 16 Manual De Instrucciones

Installation

Installation conditions

Installation location
The pool heat pump must be installed outdoors with a distance greater
than 3,5 m (140 ") from the Pool according to laws in force (NF C 15 100) in
France. Check local laws before installing if outside of France.
Install the pool heat pump on a flat, horizontal, and stable surface.
(Concrete base would be ideal).
Maintain at least 1 m (40 ") of space on the rear (evaporator air inlet) and
3m (120 ") on the outlet side of the fan.
Outlet air flow:
3 m (120 " )
Provide enough space to allow access to temperature controller.
Make sure that the discharged air will not be sucked back into the
evaporator again.
To improve your installation
Avoid directing the flow of ventilated air towards a noise sensitive area (room
window for example), or a space where people normally gather (the discharged
air will be cold)
Avoid positioning the pool heat pump on a surface that can transmit vibrations.
Try to avoid placing the appliance under a tree or exposed to water or mud,
which would be likely to complicate performance and maintenance.
Inlet air flow:
1 m (40 " )
- 43 -