DJO ARTROMOT-E2 Instrucciones De Uso página 75

grammed therapy duration, it will stop
automatically.
During warm-up, the display will show
the symbol in the upper, left-
hand corner.
Default: disabled
Follow these steps to program the special
function:
• Access menu level 4, then press the
parameter key to select the special
function .
The display will indicate:
– the symbol representing the special
function
– the status of the special function
(circle with or without check mark)
– two boxes with the current percent-
age of the stop positions for motor A
and B
– a check mark in a circle.
• You activate the function with the "+"
key and deactivate it with the "-" key.
In this case it is not possible to activate/
deactive the function by pressing the
parameter key again.
A check mark in the circle identifies the
activated function.
• Next press the parameter key of the
isolation protocol. The marking moves
to the upper percentage value, allowing
you to enter the stop position for
motor A.
• To modify the value, press the "+" (plus)
or "-" (minus) key.
Select 75%, for instance.
• Press the parameter key again when
done. The marking automatically moves
to the lower box, allowing you to adjust
the stop position of motor B.
• To modify the value, press the "+" (plus)
or "-" (minus) key.
Select 25%, for instance.
• Save the programmed values by press-
ing the STOP key, then press the START
key to begin the treatment.
This is what happens:
Extension/flexion is treated three times
first (motor A). Motor B is positioned at
25% of the programmed range of motion
for pronation and supination.
Subsequently, pronation/supination is treat-
ed once (motor B). Motor A is positioned at
75% of the programmed range of motion for
extension and flexion.
Note!
The percentage values can be modified
only when the special function is enabled
(check mark).
n Total therapy time
Under menu item "total therapy time"
you can view each patient's total therapy
time (duration of all the patient's therapy
sessions).
Deleting the stored therapy time:
Press and hold the parameter key for
5 seconds or select the "new patient"
function.
n Extension/flexion therapy
documentation
This is a special function of the
ARTROMOT®-E2/-E2 compact which
allows the entire therapy documentation
to be represented.
The carriage run times as well as the
range of motion of the sessions are
recorded.
The collected data are presented graph-
ically in the form of a coordinate system
(X-axis = range of motion / Y-axis =
time) where the upper curve illustrates
the trend of the flexion movement and
the lower curve the trend of the exten-
sion movement.
70