Rola 59685 Guia De Inicio Rapido

NOTICE: Crossbars can cause wind noise. Remove Crossbars when not in use.
Your Crossbars come pre-assembled.
Ensure that the roof side rails
are clean and free from dust
and grease.
Straps are to be extended to
allow easy mounting of the
Crossbars. (Fig 1)
Remove the Mounting Hole Plugs.
Place in safe place to reuse them if
Mounting Brackets are removed. Install
Mounting Bracket in orientation shown
using Flat Washers, Star Washers and
Bolts. Tighten securely (25 Inch lbs or 3
Nm torque) (Fig 2)
Place the Crossbars onto the
vehicle's roof side rails (note,
ensure alignment with
Mounting Bracket). Gradually
tighten bolts alternating sides
with the security wrench
ensuring straps are properly
engaged and even tension (20
inch lbs or 2.5 Nm Maximum
torque) is achieved. (Fig 3 a, b)
There may be the need to
guide the strap into position.
Reverse procedure to remove.
It is advisable to leave the
Mounting Brackets on the
vehicle for quick installing and
removal of cross bars.
Crossbar's locking end caps may be removed to access the
accessory T-slot channel. (Fig 4)
Service buffer strips may be purchased should the buffers need
to be cut around accessories.
REGULARLY CHECK THE TIGHTNESS OF LOCKING STRAPS.
Loads should be evenly distributed and secured
Check the function of all doors and sunroof before driving.
Any weight carried on the vehicle will adversely affect its handling particularly in cornering or in a cross wind and the vehicle should
therefore be driven with increased caution.
For lost Key or Security Wrench replacement or other service items call customer service: 1-800-632-3290 or visit:
Please have lock core number or part numbers available.
Only use NON-STRETCH tie down straps.
A number of accessories for carrying special loads are available.
59685N Rev B 5/21/15
GM Suburban, Tahoe, Yukon,
Yukon XL, Escalade
2015-On
Fitting Instructions
Cross bar
Slot
End Support
End Support
Roof Side Rail
Front of
Vehicle
Vehicle roof
Roof Side Rail
Actual roof side rails may be different
.
Printed in China
PART No:
CARRYING CAPACITY:
End
Support
CAUTION!
SHARP
EDGES
Vehicle's
Roof Rail
Rubber
Mounting Hole
Pad
Plugs
Mounting
Bracket
Crossbar
Security
Roof Side Rail
Wrench
!
NOTE: Do not over tighten bolts.
Mounting
Brackets
Crossbar
End Cap
Ensure bars are parallel and straps are tightened against
the side rails. Perform a check by tugging on the Crossbars.
59685
75Kgs/
165 Lbs
Fig 1
Extended
Position
Strap
Note: Do Not Extend beyond thread of bolt.
Fig 2
Flat Washer
Star Washer
M6 x 20mm
Fig 3 a
Strap
Extended Position
Properly engaged
Strap
Mounting
Bracket
Fig 3 b
Fig 4
www.rolaproducts.com.
Pg 1 of 1
Bolt