Rola 59686 Manual De Instrucciones

NOTICE: Crossbars can cause wind noise. Remove Crossbars when not in use.
Your Crossbars come pre-assembled.
Ensure that the roof side rails
are clean and free from dust
and grease.
Straps are to be extended to
allow easy mounting of the
Crossbars. (Fig 1)
Place the Crossbars onto the
vehicle's roof side rails (note side
rails may have a position marking
on them). Gradually tighten bolts
alternating sides with the security
wrench ensuring straps are
properly engaged and even
tension is achieved. (Fig 2) There
may be the need to guide the strap
into position.
Reverse procedure to remove.
Crossbar's locking end caps may
be removed to access the
accessory T-slot channel. (Fig 3)
Service buffer strips may be
purchased should the buffers
need to be cut around
accessories.
Place Crossbars on the
vehicle at the
recommended
positions shown along
the Roof Side Rails.
( Fig. 4)
REGULARLY CHECK THE TIGHTNESS OF LOCKING STRAPS.
Loads should be evenly distributed and secured
Check the function of all doors and sunroof before driving.
Any weight carried on the vehicle will adversely affect its handling particularly in cornering or in a cross wind and the vehicle should
therefore be driven with increased caution.
For lost Key or Security Wrench replacement or other service items call customer service: 1-800-632-3290 or visit:
Please have lock core number or part numbers available.
Only use NON-STRETCH tie down straps.
A number of accessories for carrying special loads are available.
59686N Rev A 4-6-15
Jeep Renegade with Side Rails
2015-On
Fitting Instructions
Cross bar
End Support
Roof Side Rail
Lock Barrel
150mm / 6" forward
of door seam
Front of Vehicle
Front Door
Actual roof side rails may be different
.
Printed in China
PART No:
CARRYING CAPACITY:
End
Support
CAUTION!
SHARP
Slot
EDGES
End Support
Security
Wrench
End Cap
Crossbar
700mm/ 27-1/2"
Rear Door
Ensure bars are parallel and straps are tightened against
the side rails. Perform a check by tugging on the Crossbars.
59686
Strap
Crossbar
Note: Do Not Extend beyond thread of bolt.
Extended Position
Properly engaged
Roof Side Rail
!
NOTE: Do not over tighten bolts.
Crossbar
www.rolaproducts.com.
Pg 1 of 1
75Kgs/
165 Lbs
Fig 1
Extended
Position
Fig 2
Strap
Strap
Fig 3
Fig 4