Top View - Friedrich SS Serie Instrucciones Para La Instalación

STEP 3 STEP 3 W W W W W ALL PREP ALL PREP ALL PREP ARA ARA
STEP 3 STEP 3 STEP 3 ALL PREP ALL PREPARA ARATION: ARA
by the model size to be installed. THE OUTSIDE CABINET CONDENSER
B B B B B Y EXTENDING INSIDE THE W Y EXTENDING INSIDE THE W Y EXTENDING INSIDE THE W Y EXTENDING INSIDE THE W Y EXTENDING INSIDE THE WALL AREA.
gram in Figure B.
SPECIAL INSTRUCTIONS FOR EXTRA THICK W SPECIAL INSTRUCTIONS FOR EXTRA THICK W
SPECIAL INSTRUCTIONS FOR EXTRA THICK WALLS: SPECIAL INSTRUCTIONS FOR EXTRA THICK W SPECIAL INSTRUCTIONS FOR EXTRA THICK W
shown in the chart, the following suggested construction may apply.
FIGURE B
MAXIMUM WALL
THICKNESS
MODEL
SMALL CHASSIS
MEDIUM CHASSIS
LARGE CHASSIS
STEP 4 STEP 4 STEP 4 STEP 4 STEP 4 CHECKING WIRING AND PLUMBING: CHECKING WIRING AND PL CHECKING WIRING AND PL CHECKING WIRING AND PL CHECKING WIRING AND PL
sure none will be broken where the hole is to be cut.
STEP 5 STEP 5 STEP 5 STEP 5 STEP 5 HOLE CONSTRUCTION: HOLE CONSTRUCTION: HOLE CONSTRUCTION: Depending upon size of unit to be installed, lay out the hole dimensions per the HOLE CONSTRUCTION: HOLE CONSTRUCTION:
chart below. Cut and frame in hole to finished dimensions. Use 2" x 4" material for framing and follow the
suggested typical installations in Figure C, D, or E on page 12.
NOTE: IF THE WALL CONSTRUCTION IS TYPICAL FRAME OR 2 X 4 STUDDING WITH BRICK OR STONE VENEERS, L NOTE: IF THE W NOTE: IF THE W NOTE: IF THE W NOTE: IF THE W ALL CONSTRUCTION IS TYPICAL FRAME OR 2 X 4 STUDDING WITH BRICK OR STONE VENEERS, LOCA ALL CONSTRUCTION IS TYPICAL FRAME OR 2 X 4 STUDDING WITH BRICK OR STONE VENEERS, L ALL CONSTRUCTION IS TYPICAL FRAME OR 2 X 4 STUDDING WITH BRICK OR STONE VENEERS, L ALL CONSTRUCTION IS TYPICAL FRAME OR 2 X 4 STUDDING WITH BRICK OR STONE VENEERS, L
NEXT TO ONE OF THE STUDS. FOR MASONR NEXT TO ONE OF THE STUDS. FOR MASONR NEXT TO ONE OF THE STUDS. FOR MASONR NEXT TO ONE OF THE STUDS. FOR MASONRY Y Y Y Y , CONCRETE OR CINDER BL NEXT TO ONE OF THE STUDS. FOR MASONR
TION: TION:
TION: The maximum wall thickness permissible without special construction is determined TION:
THE OUTSIDE CABINET CONDENSER THE OUTSIDE CABINET CONDENSER THE OUTSIDE CABINET CONDENSER- - - - - AIR THE OUTSIDE CABINET CONDENSER
ALL AREA. Observe the maximum wall thickness shown in the chart and dia- ALL AREA. ALL AREA. ALL AREA.
CONDENSER
AIR INTAKE
LOUVERS
TOP VIEW SHOWING
BEVELED SIDES FOR AIR
INTAKE. WALL BELOW
UNIT MUST BE BEVELED
ALSO.
A
7-3/8"
7-3/8"
15-1/8"
UMBING: UMBING: UMBING: UMBING: Check all wiring and plumbing inside and outside of the wall to be
, CONCRETE OR CINDER BL , CONCRETE OR CINDER BL , CONCRETE OR CINDER BL , CONCRETE OR CINDER BLOCK W
NOTE: THESE DIMENSIONS ARE FOR FINISHED HOLE SIZE.
ALLS: ALLS:
ALLS: For installation in walls exceeding the maximum thickness ALLS:

TOP VIEW

CONDITIONED ROOM SIDE AIR
CONDENSER AIR
OUTLET
REJECTED HEATED
AIR
EXTRA THICK WALL CONSTRUCTION
OCK W OCK W OCK WALLS, L OCK W
FINISHED SMALL
DIMENSION CHASSIS
A 16-3/16"
B 26-3/16"
AIR-INT AIR AIR AIR -INTAKE-L -INT -INT -INT AKE-L AKE-LOUVERS MUST NOT BE BL AKE-L AKE-L OUVERS MUST NOT BE BL OUVERS MUST NOT BE BL OUVERS MUST NOT BE BLOCKED OUVERS MUST NOT BE BL
2" MINIMUM
BOTH SIDES
CONDENSER AIR
INTAKE LOUVERS
NOTE: Condensor air inlets
and outlet must be
unobstructed to avoid the
recirculation of rejected
heated air.
ALLS, L ALLS, L ALLS, LOCA ALLS, L OCA OCA OCA OCATE HOLE FOR CONVENIENCE. TE HOLE FOR CONVENIENCE. TE HOLE FOR CONVENIENCE. TE HOLE FOR CONVENIENCE. TE HOLE FOR CONVENIENCE.
MEDIUM LARGE
CHASSIS CHASSIS
18-3/16" 20-3/16"
26-3/16" 28-1/2"
OCKED OCKED OCKED OCKED
OCATE THE HOLE OCA OCA OCA TE THE HOLE TE THE HOLE TE THE HOLE TE THE HOLE
Page 11