Descargar Imprimir esta página

Friedrich SS Serie Instrucciones Para La Instalación página 7

Ocultar thumbs Ver también para SS Serie:

Publicidad

Idiomas disponibles

Idiomas disponibles

FIGURE G
SECURE THE SIDE WINGBOARD PANELS TO
THE SIDE ANGLES WITH FOUR (4) #8 X 1/2"
LONG SCREWS (ITEM #11), TWO ON EACH
SIDE.
FIGURE H
STEP 13
STEP 13
STEP 13
STEP 13
STEP 13
When possible, caulk the outside of the installation with industrial type caulking to prevent weather
leaks.
STEP 14
STEP 14
STEP 14
INSTALL CHASSIS:
INST
INST
ALL CHASSIS:
ALL CHASSIS:
ALL CHASSIS: With assistance, lift the chassis by the base pan and slide it into the cabinet, stopping 3"
STEP 14
STEP 14
INST
INST
ALL CHASSIS:
before full insertion. Stuff the chassis seal gasket (Item # 14) 1" deep between the chassis and the
cabinet. Begin at either bottom corner and go up the side, across the top, and down the opposite side.
It is important that this gasket be properly installed as it prevents air leakage around the chassis be-
tween the outdoors and the indoors. Push the chassis into the shell the remaining 3" so that the plastic
front shrouds the front edge of the cabinet (See Figure I, Page 8).
STEP 15
STEP 15
STEP 15
STEP 15
STEP 15
Reattach the chassis retainer with the same screw as Step 3 (See Figure A, Page 3).
STEP 16
STEP 16
STEP 16
STEP 16
STEP 16
OPTIONAL:
OPTIONAL:
OPTIONAL: The factory assembles the supply cord so that it exits the left side of the unit. At the consumer's
OPTIONAL:
OPTIONAL:
discretion, the supply cord can be made to exit the right side of the unit. To do this, remove the black
rubber coated cord clamp from under the far left screw (See Figure J, Page 8). Replace this screw
back into the far left screw hole. Route the supply cord through the top of the return air grille clips and
reattach the clamp and chassis retainer under the far right screw. (See Figure J, Page 8).
LOWER WINDOW SASH
VINYL WINDOW SEAL
GASKET
TOP WINGBOARD ANGLE
SECTION B - B
TOP OF CABINET
PLACE WINGBOARD PANEL IN WINDOW
JAM TO COMPRESS THE SPRINGS INSIDE
THE RUNNERS, AND SWING THE PANEL
INTO PLACE INDICATED BY THE DOTTED
LINE.
WINDOW JAM
SECTION A - A
VINYL WINDOW SEAL
GASKET (ITEM #12)
FOAM WINDOW SEAL GASKET
(ITEM # 13)
Page 7

Publicidad

loading