Front Wheel Assembly - Medline MDS86845B Guia Del Usuario

Front Wheel Assembly

NOTE: The front wheels are the ones that swivel.
• E nsure these are mounted so that the bend turns toward the floor. Figure 6.
Figure 6
1. Insert wheel to desired height depicted by numbered holes (set to the same number
as rear wheels). Figure 7.
2. Place triangular hand screw into hole. Make sure triangular hand screw stays on the
outside of rollator frame. Figure 8.
3. Tighten triangular screw until secure (Important: Hand Tighten Only!). Figure 8.
4. Repeat steps 1-4 for other front wheel.
Figure 7 Figure 8
Chart 1
Seat Heights provided by leg adjustments (set to Dimension A above):
Hole 1
Seat Height
25" (63.5 cm)
Note: 1 is the highest, 5 is the shortest setting.
MDS86845 (GPI171)
Revised (A): 09/13/2013
Legs
Hole 2 Hole 3
24" (61 cm) 23" (58.5 cm)
Hole 4 Hole 5
22" (56 cm) 21" (53.3 cm)
7