Setting Up Your Tv; Installing Remote Control Batteries; Connecting An Antenna, Cable Tv, Or Satellite Tv Box; Connecting An Hdmi Device - Dynex DX-LCD42HD-09 Guia Del Usuario

Setting up your TV

Setting up your TV

Installing remote control batteries

To install remote control batteries:
1 Open the battery compartment cover.
2 Insert two AAA batteries into the battery compartment. Make
sure that the + and – symbols on the batteries match the + and
– symbols in the battery compartment.
3 Replace the cover.
Notes:
Do not mix different types of batteries.
Do not mix old and new batteries.
Remove batteries when they no longer have a charge. Chemicals may leak
into the battery compartment. Battery chemicals can cause a rash. If
chemicals leak, clean the battery compartment with a cloth.
Remove the batteries if you do not intend to use the remote control for an
extended amount of time.
Do not dispose of batteries in a fire. Dispose of them as hazardous waste.
Connecting an antenna, cable TV, or
satellite TV box
To connect an antenna, cable TV, or satellite TV box:
1 Connect one end of a 75 ohm cable to the RF OUT jack on the
antenna or on the cable or satellite TV box.
Antenna, cable TV, or satellite RF jack
2 Connect the other end of the cable to the RF jack on the back of
your TV.
Notes:
Use a 75 ohm cable to eliminate interference and noise from radio waves.
Do not bundle the 75 ohm cable with the power cord or other cables.
If the antenna is not installed correctly, contact qualified service personnel
to correct the problem.
Back of TV
RF jack

Connecting an HDMI device

To connect an HDMI device:
1 Make sure that your TV's power cord is unplugged and the HDMI
device is turned off.
2 Connect an HDMI cable to the HDMI OUT jack on the HDMI
device.
Back of TV
HDMI1 or
HDMI2 jack
HDMI device
3 Connect the other end of the cable to the HDMI1 or HDMI2 jack
on the back of your TV.
To play from the HDMI device:
1 Turn on your TV, then press INPUT. The INPUT SOURCE menu
opens.
2 Press or to select HDMI1 or HDMI2, then press ENTER.
Note: You can also press HDMI once for HDMI1 or twice for HDMI2.
3 Turn on the HDMI device, and set it to the correct output mode.
See the HDMI device' s user guide for more information.
Note: If the external device has DVI output only, use a DVI-to-HDMI
adapter to connect to the HDMI1 jack, then connect an audio cable to
the VGA AUDIO jack.
9
HDMI OUT jack