Description Of Symbols; General Power Tool Safety Warnings - Silverline 846386 Manual Del Usuario

GB

Description of Symbols

The rating plate on your tool may show symbols. These represent important
information about the product or instructions on its use
Wear hearing protection
Wear eye protection
Wear breathing protection
Wear head protection
Wear hand protection
Read instruction manual
Class I construction (protective earth)
Risk of electrocution
Conforms to relevant legislation and safety standards
Environmental Protection
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice
Exhaust gases contain carbon monoxide - a toxic gas.
Exposure can provoke loss of consciousness and even death
Danger of ultraviolet radiation
If the engine has been running it will be very hot.
DO NOT TOUCH
Danger of Fire
Do not use in rain or damp environments
V Volts
~ Alternating current
A
Ampere
n
No load speed
o
Hz Hertz
W, kW Watt, kilowatt
(revolutions or reciprocation)
/min or min
-1
per minute
4
Original Instructions
Specifications
Input voltage: ...........................................230V ~50Hz
Internal fuse rating: ................................................20A
Rated duty cycle: ........................................... See table
Current range: .......................................... 20-160A DC
No load voltage: .....................................................80V
Electrode size: ......................................... 1.6 – 4.0mm
Case Protection Rating: .........................................IP21
Protection Class: ....................................................
Cable length: ...........................................................2m
Weight: ................................................................5.6kg
As part of our ongoing product development, specifications of
Silverline products may alter without notice.
Guide to current and electrode selection
Electrode/rod diameter
1.6mm
2.0mm
2.5mm
3.2mm
4.0mm
Duty cycle
Guide to the duty cycle of this welder. But note, the duty cycle will be
affected by other factors such as the ambient temperature when welding
Duty cycle Welding current
20% 160A
60% 100A
100% 90A
Carefully read and understand this manual and any label attached to
the tool before use. Keep these instructions with the product for future
reference. Ensure all persons who use this product are fully acquainted
with this manual.
Even when used as prescribed it is not possible to eliminate all residual risk
factors. Use with caution. If you are at all unsure of the correct and safe
manner in which to use this tool, do not attempt to use it.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric shock, fire and/
or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-operated
(corded) power tool or battery-operated (cordless) power tool.
Work Area Safety
a) Keep work area clean and well lit. Cluttered or dark areas invite
accidents
Welding current
40-50A
50-65A
65-80A
90-120A
130-160A
Working voltage
26.4V
24.0V
23.6V