vitapur VWD1066BLS Manual De Uso Y Cuidado página 8

Ocultar thumbs Ver también para VWD1066BLS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

READY-TO-DISPENSE INDICATOR LIGHTS
RED
BLUE
YELLOW
Operation
1. DISPENSING ROOM AND COLD WATER
2. ADJUSTING THE COLD WATER TEMPERATURE
² By turning the thermostat (M) at the back of the unit,
the temperature can be adjusted. Turn the dial clock
wise between the Min. (cool) and Max. (colder) levels
until the desired temperature is reached.
Note:
If the water dispenser is not
dispensing water, there could be a possible
ice build up due to the thermostat being
set too cold. If this happens, unplug the
dispenser overnight and then reset. Set
thermostat to Min, slowly increasing based
on your use and need for cold water.
FLASHING
STEADY ON
OFF
STEADY ON
OFF
FLASHING
OFF
1
1
Heater (hot water tank) is operational
The hot water has reached optimum
temperature and is ready for dispensing
Hot water tank heating system is off, however
water within the tank may still be very hot,
always exercise caution when dispensing and/
or draining water from the hot water tank
The cold water has reached optimum
temperature and is ready for dispensing
The cooling cycle is in progress. It is possible
to dispense water during the cooling cycle,
however, optimum cooling temperature may
not yet be achieved
Low water level inside internal reservoir. The
water bottle is empty
The status of all water levels are normal
2
2
3
3
TEMP
Min.
Max.

Publicidad

Tabla de contenido
loading

Tabla de contenido