Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
1. DISPENSING COLD WATER
2. ADJUSTING THE TEMPERATURE (COLD WATER ONLY)
NOTICE: This model Water Dispenser left the factory with the cold
water temperature control factory "default setting" positioned for
"Energy Star" compliance (identified to the side). This setting will
deliver cold water temperatures between 8°C ~ 10°C (46.4°F ~
50°F) The cold water temperature can be adjusted, (using a
flat screwdriver) by rotating the adjustment screw clockwise or
anti-clockwise between "Min" (cool) and "Max" (colder) until the
desired temperature is reached. NOTE: Any change/adjustment
to the cold water temperature control may effect Energy Star
efficiency.
3. DISPENSING HOT WATER
Important:
feature (low water level sensor) that controls activation/operation of the hot water
tank heating system. If no water is present and/or low water levels are detected
inside the internal water reservoir, activation/operation of the hot water heating
system is not possible. Likewise, if the hot water heating system is operational
and water is being drawn simultaneously causing internal water levels to drop
below the established minimum level set point, hot water tank operation is
automatically suspended. To reactivate the hot water heating system, you
only need to replenish the water supply and heating will resume automatically.
Operation of the cold water system is not affected by this safety feature.
TEMP
Min.
Max.
COLD WATER
WARNING: Hot water temperatures can reach 94C/201F and produce severe scalding, never let
children dispense water without direct adult supervision.
1
Your Vitapur® water dispenser is designed with a special safety
1
2
NOTE: The lower front panel must be installed
otherwise hot water heating is not possible.
2
3
ENERGY STAR FACTORY
DEFAULT SETTING
TEMP
Min
Min.
Max
Max.
COLD WATER
3
Publicidad
Tabla de contenido
