Care And Cleaning Instructions; Limited One-Year Warranty - Kohler K-1397 Guia Del Usuario

Programming the Remote Control (cont.)
Turn off all modes of operation. Wait approximately one minute until the keypad darkens
completely.
On the user keypad, press the up arrow, down arrow and the "OK" button simultaneously. The
bottom LED, on the keypads indicator bar, will begin flashing.
While the LED is flashing, press the "OK" button on the keypad. A light sequence will illuminate
up and down the indicator bar.
While the indicator bar light sequence is active, press any button on the remote control. The
program will download and the user keypad will darken. The user keypad will now respond only
to this remote control.

Care and Cleaning Instructions

Cleaning Your Acrylic Bath Whirlpool
Do not use abrasive cleansers or solvents on acrylic surfaces.
Wipe out your acrylic whirlpool with a soft cloth after each use.
Avoid detergents, disinfectants, or cleaning products in aerosol cans.
If the surface gets excessively dirty you can use a general purpose cleaner such as: Formula 409
Purpose Cleaner, Gel Gloss
Lemon Fresh, Cinch
NOTE: To restore dull or scratched units: Apply white automotive polishing compound with a clean rag.
Rub scratches and dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste
wax. Do not wax areas where you walk or stand.
Cleaning Your User Keypad and Remote Control
Use a soft cloth to wipe the keypad and remote control after each use. If the surface becomes dirty,
use a non-abrasive soap and warm water to clean.
Cleaning Your User Removable Pillows
Clean your pillows twice a month or more, depending upon usage. Use mild soap and water on a
clean, soft cloth for routine cleaning. To clean stubborn stains, remove the pillows from the
whirlpool and use a high-quality cleaner recommended for vinyl. Periodically, use a vinyl treatment
product to rejuvenate the appearance of your pillows.
Flushing Your Whirlpool System
Flush your whirlpool system twice a month or more, depending upon usage. Use the following
sequence:
• Turn the jet trim rings fully clockwise to remove air induction.
• Fill the whirlpool with warm water to a level at least 2" (5 cm) above the highest jets, or leave
water in the whirlpool after using.
• Add 2 tablespoons (30 ml) of a low-foaming dishwasher detergent and 20 ounces (590 ml) of
household bleach (5% - 6% sodium hypochlorite) to the water.
• Run the whirlpool for 5 to 10 minutes. Turn off the whirlpool and drain.
• If desired, rinse the bath surfaces with water.
• Rinse the surfaces of the jets, faucet, handrails, drain, etc. and wipe them dry with a soft cloth.

Limited One-Year Warranty

For the U.S.A. and Canada Only
KOHLER plumbing fixtures, faucets and fittings are warranted to be free of defects in material and
®
workmanship for one year from date of installation.
Kohler Co. will, at its election, repair, replace or make appropriate adjustment where Kohler Co. inspection
1022205-5-C
(Bath and Shower only), Scrub Free
®
, Glass Plus , or Fantastik
® ®
Mildew Stain Remover, Mr. Clean
®
All Purpose.
®
10
All
®
Kohler Co.