Care And Cleaning - Project Source H90-K51D-PS-BN Manual De Instrucciones

Ocultar thumbs Ver también para H90-K51D-PS-BN:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS
5.
Optional Escutcheon Installation:
NOTE: Optional eschutcheon cannot be installed with flange.
Remove the flange (1) and place the escutcheon (B) with gasket (C) on the
bottom of the new faucet body assembly (A). Apply a thin bead of silicone
sealant to the underside of the gasket (C).
6.
To connect to the water lines, use 1/2 in. IPS faucet supply lines (1) or
coupling nuts (2) with ball-nose risers (3). Parts not included.
Turn on water supply or shut-off valve and check for leaks. If leaks occur,
gently tighten the faucet connections.
NOTE: When making water line connection, HAND TIGHTEN. DO NOT
OVERTIGHTEN. Do not use PTFE pipe tape, plumber's putty, pipe dope
or any other type of sealing compound on water inlet or threads. Additional
compound is unnecessary. A water tight seal between the thread inlet and
supply tube is achieved by compression.
7.
After installation is complete, turn on the water supply to check for leaks.
Remove the spray head (3) by unscrewing it from the hose assembly (1) in
a counterclockwise direction. Be sure to hold the end of the hose assembly (1)
down into the sink and turn on the faucet handle (2) to the warm position where
it mixes hot and cold water. Flush line for one minute. Check for leaks. Re-
tighten any connections if necessary, but do not overtighten. Reinstall the
spray head (3) by hand tightening it back onto the hose assembly (1).
OPERATING INSTRUCTIONS
The lever handle controls the flow of hot and cold water to the faucet.
Rotate the handle forward for cold water. Rotate the handle backward for hot water. Moving the handle out from the faucet body
(right) opens the cartridge and causes water to flow from the spout. The degree of handle opening determines the volume of
water flow. Returning the handle to the original position (toward the faucet body) stops the flow of water.

CARE AND CLEANING

Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the finish and
void your warranty.
5
5
A
B
6
1
3
2
7
1
3
1
C
2

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

1452262

Tabla de contenido