Automatic Defrosting; Cleaning And Maintenance - Woods MDK21 Manual De Instrucciones

Operating Instructions
GB

AUTOMATIC DEFROSTING

Wood's dehumidifiers are fitted with
a control unit which ensures that the
cooling coils are defrosted automatically
when needed. The control shuts
down the compressor, which causes
the cooling of the coils to stop. The
fan continues to draw the air at room
temperature through the dehumidifier
and thus melts the ice, and the water
runs down into the reservoir. This
defrosting system means that the
dehumidifier works at temperatures as
low as +5˚C.
FAN
The fan ensures that air flows through
the dehumidifier. Moist air is sucked in
from the rear and goes via the cooling
coil and the vaporizer to come out dry
and warm at the top of the dehumidifier.
Wood's dehumidifiers are fitted with two
fan speeds.
• Position II – gives a high air flow with
maximum dehumidifying of air.
• Position I – gives a lower air flow
which causes quieter operation
and somewhat lower dehumidifying
capacity.

CLEANING AND MAINTENANCE

Wood's dehumidifier require cleaning
of filter, to maintain their high
dehumidifying capacity.
- The fan motor is permanently lubricated
and requires no maintenance.
NOTE: Always disconnect the cord
before cleaning.
HINTS:
- Sometimes it may be useful to use a frost
guard or heater fan to make sure that the
temperature does not fall below +5˚C.
- For maximum dehumidifying power in
a room, it is recommended that the air
supply from outside and from adjoining
rooms is minimized – close doors and
ventilators.
8
- Put in the center of the room
- Increase temperature. for faster
dehumidification
( Warm air carries more water.)
- Use frost guard if temperature falls below
+5°C
- Higher dehumidification in autumn /
summer because outside air is warm and
humid. (Absolute humidity is normally
higher).
WHEN THE DEHUMIDIFIER REQUIRES
SERVICING
If the dehumidifier requires servicing,
you must first contact the retailer. Proof
of purchase is required for all guarantee
claims.
GUARANTEES
2 year´s guarantee against faults in
manufacture. Note that the guarantee is
only valid with a valid proof of purchase.
NOTE! Get a 3-years warranty! Register
at warranty-woods.com. Please visit
woods.se for more information.
Recommended limits for use
Temp. MDK +5˚C to +35˚C
Relative humidity: 30% to 90%
Recommended
humidity level: Appr. 50% RH
IMPORTANT! - Wood's
dehumidifiers must be connected
to an grounded power source.
The power source sould be
220V-240V 50Hz