Technical Data - Woods MDK21 Manual De Instrucciones

Operating Instructions
GB

TECHNICAL DATA

Max. working area
Air flow step 1
Air flow step 2
Dehumidifying at 30˚C and 80% r.h.
Power at 30˚C and 80% r.h.
Tank volume
Refrigerant
Voltage
Frequency
Currentt
IP Code
Dimensions in mm, L x B x Hs
*Technical changes and improvements may occur. All values are
approximate and may vary due to external circumstances such as
temperature, ventilation and humidity.
PROBLEM
Dehumidifier does not work
Does not dehumidify
The dehumidifier works, but
reduces the relative huidity
insufficiently.
HI
LO
If none of the above works, you should contact your nearest retailer for checking and possible overhaul of dehumidifier
6
MDK21 MDK26
70m 120m
2 2
132m3/h 134m /h
3
170m3/h 174m /hour
3
20 l/24h 25l/24h
275 W 320 W
4 liters 4 litres
R290 (70g) R290 (75g)
230 V 230 V
50 Hz 50 Hz
1,25 A 1,4 A
IPX1 IPX1
346x242x596 346x242x596
CAUSE SOLUTION
The power is not connected - Check that dehumidifier is connected to electricity and that fuse has not gone
- Check that the water reservoir is empty and correctly placed in the dehumidifier.
-The water container is full. - Remove the water from the container.
-The water container has not - Place the water container in the correct position.
been replaced correctly.
-The air filter is clogged. - Clean the air filter.
The temperature or relative
humidity in the room where
the device is operatingis too low.
- Check that air can flow freely through the dehumidifier. Front grid and air filter should be clean and dehumidifier should stand
20-30cm from wall
- Check that a thick coating of ice has not formed on the cooling coils.
-The room is too large. - We recommend using a dehumidifier with a greater capacity.
-There are too many sources - We recommende using a dehumidifier with a greater capacity.
of humidity.
-There is too much ventilation. - Reduce ventilation (e.g close windows and shut doors.)
The humidity is higher than > 80% When the humidity level is below < 80%, the display switches over to normal display mode.
The humidity level is below < 30% When the humidity level is over > 30% the display switches over to normal mode.
Air Plate
Top cover
Front casing
Back casing
Intake
Pull-out hook
Water tank
Control panel
Power cord
Continuous drain pipe
Window for water level