General Warnings - AUtec E16 Serie Manual De Instalación Y Funcionamiento

All KTC systems (KIT for TRANSMISSION of COMMANDS) comply with:
-the R&TTE99/05/EEC Directive and with its essential requirements
- the norms given in the EC Declaration of Conformity that is included in this manual.
It should be remembered that in some countries must be respected rules which control:
- the use and/or possession of a radio remote control;
- the use of operational frequencies which have not yet been harmonised in Europe
(see "Limitations & Authorisations" sheet).
Autec cannot be held responsible if the radio remote control is installed on applications
that are different from those permitted
- Telemetry, signal systems
- Transmission of commands for machines which lift and move material
- Transmission of a safety command
WARNING: Follow the instructions carefully on pages 20, 21 and 22
- Machines installed in environments where equipment with explosion-proof
characteristics are being used
- Transmission commands for machines which lift and transport people
WARNING: Connect the POWER SUPPLY to the KTC only by means of a Safety Transformer
(see EN60204-32 paragraph 6.4).
Permission to install and to use the KTC is to be given exclusively to qualified personnel.
As required by the Machines Directive and relative harmonised standards, all machines must undergo a risk
analysis; therefore it is necessary to evaluate, within the limits of this analysis, if the machine can be radio
remote controlled.
The machine producer and/or the person who decides upon radio remote control use and installation is
responsible for this analysis.
Autec cannot be held responsible if the risk analysis is not carried out correctly.
To guarantee correct radio remote control operation, all current regulations regarding safety at work and
accident prevention should be respected. All current user country national laws regarding the use of both the
machine and the radio remote control MUST ALWAYS be respected.
Autec cannot be held responsible if the radio remote control is used in unlawful working conditions.
Autec will not accept any responsibility if the KTC is:
- installed for applications which are not authorised
- used in working conditions which do not conform to the relevant regulations
- is not installed by qualified personnel
If a fault or breakdown occurs in the KTC, do not use the KTC until the problem has been completely
resolved.
When damaged parts need to be replaced, qualified personnel have to carry out this operation using original
Autec spare parts.
Page 14
1.1 Conformity
1.2 Applications
:
PERMITTED APPLICATIONS:
FORBIDDEN APPLICATIONS

1.3 General warnings

ENGLISH
LIKTCIU2