Antenna Installation - AUtec E16 Serie Manual De Instalación Y Funcionamiento

Each of the two units requires an antenna. The antenna is not to be installed
on the electrical board.
It is to be installed:
- on a metal assembly surface (clamp, the electrical board ...)
- in such a way as not to be covered by metal structures.
The monopole must not come into contact with metal
parts.
If possible, avoid installing a KTC near antennas of other radio
equipment. Otherwise, take the position of the antenna into
consideration and install the antennas in such a way as to ensure that
both sets work properly (calculate the position, the direction and the
distance of the antenna on the basis of use and the working
environment).
Assembly
1
Assemble the parts of the
antenna on the metal surface
support (for the order see the
previous photo).
2
Insert one part of the cable
into the connector on the
antenna and the other into the
antenna connector (G) on the
unit.
LIKTCIU2

3.3 Antenna installation

Antenna installation (assembly and disassembly)
ENGLISH
monopole
metal
assembly
surface
Disassembly
2
D i s m a n t l e t h e a n t e n n a
removing it piece by piece from
the metal surface support.
1
Disconnect the unit from the
power supply. Remove the
cable from the connector on
the antenna and from the
antenna connector (G) on the
unit.
Page 19