Use Of The Tli (Lower Limit Temperature); Service Submenu Settings - Solera ECO Soft Manual De Uso Y Mantenimiento

6. To exit the menu press the
The application Defrost described cannot be used in Hong Kong in according with rules. The Solera ECO Soft
machine has to be empty and sanitized daily.
If the machine is in "WAIT PLEASE" status, the product should not be ready to be served, but sometimes this might not
be true. If so, the customer can use the TLI function setting the correct temperature for the product.
In order to set the TLI see the following procedure:
1. Press the button on the electronic control panel to view the menu entries
2. Press the or
3. If you press the
following example the temperature is -6,4°C/20.5°F
4. Notice the temperature
5. Press the button to return to the previous screen
6. Press the or
7. Press the button to see the TLI temperature set on the control electronic board. In this example it is -
8,0°C/17.6°F
8. Set the new TLI with the
9. After setting the temperature, press the
10. To exit the menu press the
The TLI value can vary between a minimum of -8.5 °C (17.6°F) to a maximum of -1.0 °C (30.2°F).
Solera ECO Soft is supplied with a number of pre-established, default settings, which can be used for various products.
The settings are as follows:
Service step V1
Service step V2
Service step V3
RTS Time
EV OFF Time
button.

Use of the TLI (Lower Limit Temperature)

buttons until you reach the TANK TEMPERAT. screen
> TANK TEMPERAT.
button, on the lower line of the display you can see the temperature of the product. In the
TANK TEMPERAT.
-6,4°C •
buttons until you reach the TLI screen
>
TLI
-8,0°C
or buttons to the temperature reported at number "4"
TLI
-6,4°C
button

Service submenu settings

V1= 50rpm (default)
V2= 50rpm (default)
V3= 30rpm (default)
10 minutes (default)
10 minutes (default)
TANK TEMPERAT.
20.5°F •
TLI
TLI
17.6°F
TLI
20.5°F
button
T1= -8,5°C/16.7°F (default)
T2= -8,5°C/16.7°F (default)
RTS= not settable
- 30 -