Protection Against Overheating; Trickle Charge; Connecting The Charger - auto XS CPL-2054U Manual Del Usuario

USA
Operation
Fault protection function
If the charger detects a short circuit, contact interruption or incorrect polarity
while charging, the charger will automatically end the charging program and
switch to standby mode

Protection against overheating

If the temperature of the heat sink inside the charger increases to 212 °F
(100 °C), the charger will reduce the charging current until the heat sink has
cooled down to normal operating temperature.

Trickle charge

Once the battery is fully charged, the charger will automatically switch to trickle
charge. At the same time, the charging process will be interrupted depending
on the voltage measured or the full charge of the battery will be maintained
with low charging currents of 0.07 A and 0.8 A.
• The battery can be continuously connected to the charger
• The trickle charge can be used to maintain a battery.

Connecting the charger

WARNING!
Danger of explosion!
An electrical short-circuit may occur if connected incorrectly.
Sparks may form that could trigger an explosion.
− Always start by connecting the battery to the charger.
Then insert the power plug of the charger in the socket.
This is the only way to prevent the formation of sparks.
− Never connect the charger with the grid if the red error in-
dicator lights up. Check to make sure that the battery ter-
minal clamps red (+) and black (-) are correctly assigned to
the poles (+/-) of the battery.
− Be absolutely sure to observe the steps described in this
section.
16
customer-service@wk-usa.com
14
(see fig. C).
without this resulting in damage or loss of battery power.
AFTER SALES SUPPORT
1 888 367 7373
USA