Danger Of Explosion; Starting The Charging Process - auto XS CPL-2054U Manual Del Usuario

USA
Operation
WARNING!

Danger of explosion!

In general, the negative pole (-) of the car battery is connected
with the chassis. But there are also exceptions. When connect-
ing the battery terminal clamps, reversing the poles may result
in a short-circuit, sparks and an explosion.
− Check which of the battery poles (+ or -) in the vehicle is
directly connected to the chassis. This determines the or-
der for safely attaching the battery terminal clamps.
1. Check which battery pole (+ or -) is not directly connected to the chassis. If
this concerns
• the positive pole (+) of the battery, connect the red battery terminal
clamp (+)
• the negative pole (-) of the battery, connect the black battery terminal
clamp (-)
2. To connect to the vehicle chassis, connect the free battery terminal clamp
to a screw or bare metal as far away from the battery and the petrol line as
possible.
3. Connect the charger to the grid via the mains cord
As soon as the charger is connected to the grid, the following will appear on
1
the display
• the standby mode
• the empty battery symbol for the charge level indicator
• the current voltage measured for the battery
The green power supply indicator
You have successfully connected the charger.

Starting the charging process

Automatic battery detection
The charger will automatically detect the type of battery connected.
• If the voltage of the battery is less than 3.8 V or greater than 15 V, the battery
is not suitable or defective. The display will show the measured voltage
of the battery for 3 seconds. Then the error message Err will appear. The
charger is in standby mode
18
customer-service@wk-usa.com
4
to the positive pole (+) of the battery.
5
to the negative pole (-) of the battery.
14
indication
14
12
will illuminate.
(see fig. G).
2
.
11
and
15
(see fig. D).
AFTER SALES SUPPORT
1 888 367 7373
USA