Makita DLS600 Manual De Instrucciones página 25

Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
►
Fig.7: 1. Indicator lamps 2. Check
button
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for a few seconds.
Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Automatic speed change function
►
Fig.8: 1. Mode indicator
Mode indica tor status
This tool has "high speed mode" and "high torque
mode". It automatically changes operation mode
depending on the work load. When mode indicator
lights up during operation, the tool is in high torque
mode.
Stopper pin
CAUTION:
Always hold the handle when
releasing the stopper pin. Otherwise the handle
springs up
result
To release the stopper pin, keep applying a slight
downward pressure on the handle and then pulling
the stopper pin. ►
Fig.9:
Remaining
capacity
Blinking
75 % to 100%
50 % to 75%
25 % to 50%
0 % to 25%
Charge the
battery.
The battery
may have
malfunctioned.
Operation mode
High speed mode
High torque mode
and it may
in personal injury.
1. Stopper pin
Blade guard
WARNING:
Never defeat or remove the blade
guard or the spring which attaches to the guard.
An exposed blade as a result of defeated guarding
may result
injury
WARNING:
Never use the tool if the blade
guard or spring are damaged, faulty or removed.
Operation of the tool with a damaged, faulty or
removed guard
serious
CAUTION:
Always maintain the blade guard in
good condition for safe operation. Stop the
operation immediately if there are any irregularity
of the blade guard. Check to assure spring loaded
return action of guard.
►
Fig.10:
When lowering the handle, the blade guard raises
automatically. The guard is spring loaded so it returns to
its original position when the cut is completed and the
handle is raised.
Cleaning
►
Fig.11:
If the transparent blade guard becomes dirty, or
sawdust adheres to it in such a way that the blade
and/or workpiece is no longer easily visible, remove the
battery cartridge and clean the guard carefully with a
damp cloth. Do not use solvents or any petroleum-
based cleaners on the plastic guard because this may
cause damage to the guard.
For cleaning, raise the blade guard by referring to
"Installing or removing saw blade".
After cleaning, make sure to return the blade and center
cover and tighten the hex socket bolt.
1. Make sure that the tool is switched off and the
battery cartridges are removed.
2. Turn the hex socket bolt counterclockwise using
the supplied hex wrench with holding the center
cover.
3. Raise the blade guard and center cover.
4. When cleaning is complete, return the center
cover and tighten the hex socket bolt by
performing the steps above in reverse.
WARNING:
Do not remove spring holding
blade guard. If guard becomes damaged in course
of time or UV light exposure, contact a Makita
service center for replacement. DO NOT DEFEAT
OR
REMOVE GUARD.
Positioning kerf board
This tool is provided with the kerf boards in the turn
base to minimize tearing on the exit side of a cut. The
kerf boards
25 ENGLISH
in serious
during operation.
may result
personal injury.
1. Blade guard
1. Blade guard
are factory
personal
in
adjusted