Chapter 4: The Tape Player; Playing A Tape - Sony CHC-P33D Manual De Instrucciones

Chapter 4:
the Tape
Player

Playing a Tape

Recording a CD
Recording a CD: Specifying
Tape Length (time edit)
Recording a CD: Specifying
Track Order (programme
edit)
Recording From the Radio
EN
Recording From Another
Tape (dubbing)
12

Chapter 4: the Tape Player

Playing a Tape
You can use TYPE I (normal), TYPE II
(CrO ) and TYPE IV (metal) tapes. When
2
you insert a tape, the deck detects the tape
type automatically.
DIRECTION MODE
2
3
) p
DECK SELECT
0 P
1
Press TAPE.
2
Press § EJECT to open the tape
compartment. Insert a recorded tape in
deck A or B with the tape side down and
the side you want to play facing
forward. Push the center of the lid (
in the illustration above) to close the
compartment. The tape will start
playing from the front side.
3
Press ( (to play the front side) or 9
(to play the reverse side).
The tape starts playing.
If you set tapes in both decks, press
DECK SELECT to choose the deck you
want to use.
To play Press DIRECTION
MODE to select
A
One side of the tape
ß
Both sides*
Both decks in RELAY
succession**
* The deck stops automatically after
repeating the sequence five times.
** See "To play both decks in succession
(relay play)".
To
Stop play
Pause (only deck B)
Resume play after
pause (only deck B)
Fast forward
Rewind
Remove the tape
2
To play both decks in succession
(relay play)
1
Relay play always follows the following
sequence. When the reverse side of the tape
in deck B finishes playing, the following
sequence continues four more times.
Deck A
(Front side)
Deck B
(Reverse side)
1 Press § EJECT and insert recorded
tapes in both decks.
2 Press DIRECTION MODE repeatedly
until "RELAY" appears in the display.
3 Press 9 or (.
To cancel relay play
Press DIRECTION MODE repeatedly until
"A" or "ß" appears in the display.
When listening to a tape recorded with the
Dolby* B-type noise reduction system
Press DOLBY NR so that "DOLBY NR B"
appears in the display.
The setting effects both decks. Dolby noise
reduction system reduces tape hiss noise in
low-level high-frequency signals.
* Dolby noise reduction manufactured
under license from Dolby Laboratories
Licensing Corporation.
"DOLBY" and the double-D symbol a
are trademarks of Dolby Laboratories
Licensing Corporation.
One Touch Play feature
Press TAPE when the power is off.
You can listen to the tape without pressing
any other buttons when a tape is in the
deck. When a tape is not in the deck, the
system will just turn on.
Automatic Source Selection
If you press TAPE while you are listening
to other sound source, the tape deck is
selected and the play starts automatically.
Press
p
P
P
) for front side
0 for reverse side
0 for front side
) for reverse side
§ EJECT
Deck A
(Reverse side)
Deck B
(Front side)