Folding Stroller With Icsa Attached; Removing Icsa From Stroller - Britax BOB SINGLE Instrucciones

FOLDING STROLLER WITH
ICSA ATTACHED
Care must be taken when
folding and unfolding the
stroller to prevent finger
entrapment or injury.
To avoid injuries, never fold
or unfold stroller with other
individuals within reach of
stroller.
1. Set Parking Brake
Set parking brake (see stroller owner' s
manual if necessary).
2. Unfasten Restraint Belt
Unfasten buckle, place Restraint Belt ends
to sides of stroller seat.
3. Remove Infant Car Seat
Remove Infant Car Seat from ICSA.
4. Empty Stroller
Remove contents from low boy cargo
basket and pockets.
5. Fold Handlebar
Squeeze both handlebar release levers
simultaneously (see stroller owner' s
manual if necessary).
6. Rotate Handlebar Forward
Slightly rotate handlebar towards seat and
hold in place during next step.
7. Lift Red Frame Release Handle
Using a short, quick tug, lift red frame
release handle up. Keep tires on ground
as stroller collapses toward front wheel
(see stroller owner' s manual if necessary).
REMOVING ICSA FROM
STROLLER
Remove Infant Car Seat
Adapter and Restraint Belt
when not in use.
Do not place children directly
in the stroller seat with the
Infant Car Seat Adapter
installed. Remove Infant Car
Seat Adapter from stroller
prior to placing a child
directly into the stroller seat.
Failure to follow these
warnings may result in
serious injury or death.
NOTE: For illustrative purposes,
Chicco compatible ICSA shown.
Other ICSA singles remove in same
manner.
Prepare Stroller
Set parking brake, rotate canopy
towards handlebar (see stroller
owner's manual if necessary).
1. While holding down Red Release
Buttons on both Accessory Adapters
at sides of stroller, pull ICSA forward
and out of Receiver Sockets, keeping
alignment even, left to right, as you pull.
15
P637000A