Publicidad
Idiomas disponibles
Idiomas disponibles
3 INSerTINg BaTTerIeS
Remote Control
3A Unscrew and remove the cover.
3B Insert 9 V E-block 6LR61 batteries,
paying attention to the polarity, as
indicated in the battery compartment.
3C Close the battery cover and secure
with the screw.
4 STarT preparaTIoN
First move the ON/OFF switch on the remote control to "ON"; the Power LED light up.
(2A) Then move the ON/OFF button on the boat to "ON" (4A) Important! The boat
only switches on once it has been placed in the water! The boat has a range of approx.
10 metres.
Place your boat in water that is at least 20 cm deep. Make sure that there is no grass,
debris or vegetation in the water as your boat can become trapped! Align the boat so
that the stern is facing you. Important! If the boat becomes slower, immediately pilot
it back to the bank, as the motor will switch off when the batteries are depleted.
Switch off the boat and remote control after use.
5 vehICle CoNTrol
5A In order to drive forwards, push the lever for forward and reverse travel (2A) on
the left side of the remote control forwards.
5B In order to drive backwards, push the lever for forward and reverse travel (2A) on
the left side of the remote control backwards.
5C To drive along a left curve, press the right steering lever (2D) on the remote control
to the left.
5D To drive along a right curve, push the right steering lever (2D) on the remote control
to the right.
INSTruCTIoNS For SaFe drIvINg
• Always push the boat a little away from the bank.
• When choosing a suitable body of water, take into account the wind direction and the
size of the lake. We do not recommend operating the boat in flowing water, like rivers
and streams.
• Never operate the boat near swimmers, animals or real boats to rule out any danger of
collisions and damage.
• Always move the controls slowly and with a gentle touch.
• Always maintain visual contact with the boat and do not look at the remote control!
• Please keep this operating manual safe for later use.
• Only operate this boat in accordance with the instructions for use in this operating manual.
12
Model
3D Carefully turn locks anti-clockwise
3E Carefully remove the cover of the bat-
tery compartment.
3F Insert 6 x 1.5 V AA batteries, paying
attention to the polarity, as indicated
in the battery compartment.
3G Close the battery compartment cover
and turn the locks to secure.
• Switch off the remote control and the boat's electronics when they are not in use.
• Remove the batteries from the remote control and the boat when not in use.
• Always maintain visual contact with the boat to avoid losing control of it.
• Insert new batteries as soon as the remote control no longer functions reliably.
We recommend that people unfamiliar with model boats start using this model under
the instruction of an experienced user.
• Please make sure that the frequency you are using is free prior to each use.
SUITABLE BODIES OF WATER:
The bodies of water in which the boat is operated should fulfil the following criteria:
• Take into account the size, depth and wind direction when choosing a suitable body of
water. As a basic rule, only operate the boat in fresh water without a current – in other
words not in rivers, streams or salt water.
• Make sure that the body of water/area is free of obstacles, especially plants, debris,
animals or swimmers. Always watch the boat so that it does not drive into the operator,
other people or animals and injure them.
TrouBleShooTINg
Problem:
The vehicle does not move.
Cause:
1. The batteries are too weak and/or depleted.
Remedy:
1. The batteries were possibly not inserted correctly. Please observe the polarity
indication in the model
2. Please replace with new batteries.
Problem:
Remote control does not work.
Cause:
1. The batteries were not inserted correctly.
2. The batteries do not have enough power.
Remedy:
1. Check whether the batteries are inserted correctly.
2. Please replace with new batteries.
Problem:
The vehicle cannot be controlled with the remote control.
Cause:
1. The batteries are depleted.
2. The connection between the remote control and vehicle has been severed.
Remedy:
1. Insert new batteries.
2. When the model is further than 10 metres away, move towards the model
Additional tips and trick can be found online at www.revell-control.de.
ServICe NoTeS
Go to www.revell-control.de for ordering information
and tips on replacing spare parts, plus other useful
information on all Revell Control models.
www.revell-control.de
13
Publicidad
