Fanimation The Breckenfield FP7951 Serie Manual Del Propietário página 12

How to Assemble the Blades and Light Kit (continued)
4. Remove one of the three screws in the light plate
assembly. Slightly loosen the remaining two screws.
Assemble the socket plate assembly to the light plate
assembly using the two key slots. Replace the third
screw and securely tighten all three screws
(Figure 4).
5. Insert light bulb into socket (Figure 5).
CAUTION
To reduce the risk of fire, use 100-watt max. type
T4-minican JD E11 tungsten halogen bulb. Turn off
the wall switch and allow the bulb to cool for 10
minutes before relamping.
Bulb is pressurized and may shatter. DO NOT
TOUCH BULB WITH BARE HANDS. Fingerprints
may result in shorter bulb life. Remove fingerprints
with alcohol prior to use.
6. Remove the three trim screws of support bracket
from the housing ring assembly. Retain the
screws for reinstallation in next step (Figure 6).
7. Assemble the glass assembly to the housing ring
assembly using the previous trim screws (Figure 7).
Light Plate
Assembly
100-WATT
Minican
Light Bulb (1)
Housing Ring
Assembly
12
Socket Plate
Assembly
Screws (3)
Figure 4
Socket Plate
Assembly
Figure 5
Housing Ring
Figure 6
Assembly
Trim
Glass
Figure 7
Screws (3)
Assembly
Trim
Screws (3)