How To Assemble The Blades And Light Kit - Fanimation The Breckenfield FP7951 Serie Manual Del Propietário

How to Assemble the Blades and Light Kit

1. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom
edge of the blade is fully seated against the blade
arm. With a Phillips screwdriver, tighten 3/16-24x
7.5 mm washer head screws and fiber washers to
secure the blade to the blade arm (Figure 1).
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
2. Secure the blade holders to the motor assembly
using the 1/4-20x14 mm screws (Figure 2).
Periodically check blade holder hardware and
NOTE:
resecure if necessary.
WARNING
!
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
3. Connect the 2 single pin connector from the socket
plate assembly to 2 single pin connector from motor
assembly (Figure 3).
Blade holder
Blade
HARDWARE USED:
3/16-24 x 7.5 mm
WASHER HEAD
SCREWS
FIBER WASHER
1/4-20 x 14 mm SCREWS
(2 per assembly)
Motor
Assembly
HARDWARE USED:
1/4-20 x 14 mm
SCREWS
Socket Plate
Single Pin
Connector
11
3/16-24 x 7.5 mm WASHER
HEAD SCREW AND FIBER
WASHER (3 each per blade)
Figure 1
x 15
x 15
Blade Holder
Figure 2
x 10
Motor Assembly
Single Pin Connector
Socket Plate
Assembly
Figure 3