Instruction Manual
Operation
A. Load V-nails
1. Remove slider from base board (Fig. 13).
2. Decide to drive one or two V-nails. With some hardwoods (wal-
nut, etc) it may be easier to press only one V-nail in at a time.
3. Insert V-nail with sharp edge up onto pins oriented the same as
the sticker on the V-nail blocks (Fig. 14).
4. Replace slider between guides on baseboard up against corner
stop (Fig. 15).
For information on how to purchase additional V-nails see page 10.
B. Press Nails
1. Lower lever and pressure foot onto moulding.
2. Press lever completely until vise clamp bottoms on V-nail blocks
(Fig. 16).
Making a quick firm pull on the lever drives the V-nails faster
and more accurately.
3. Raise lever.
4. Remove V-nail slider.
5. Remove jointed moulding corner.
6. Repeat process of clamping a new corner of moulding and load-
ing V-nails.
C. Stacking V-Nails
It is possible to drive V-Nails directly behind the first V-Nail (stacking).
This is to make possible, solid corners in extra thick moulding 1 1/2" or
more. Care should be taken and it is advisable to practice with scrap
moulding first.
1. To start this procedure, press one V-Nail at a time.
2. Without moving the V-Nail block from its position in the V-Nail
slider, place another V-Nail on the block and replace the slider to
its original position.
3. Press the V-Nail in using slow but firm action.
Note: With some very hard woods, it may be necessary to place the
second V-Nail on the V-Nail block upside down. This is to ensure maxi-
mum contact with the first V-Nail and the second one being pushed in
underneath the first. It may also not be possible to drive it all the way
flush with the moulding, depending on wood used, in which case, it
may be necessary to sand or file the V-Nail until it is flush with mould-
ing. This should not be done until all 4 corners have been joined.
4. Repeat the process until the corner has been completely joined
and then repeat with the remaining three corners.
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 Toll Free 1 800 331 6232 www.logangraphic.com
PRO JOINER
Model F300-2
Fig. 13
Fig. 14
Fig. 15
Fig. 16
6