Troubleshooting - Logan PRO JOINER Manual De Instruccion

Instruction Manual
Trouble Shooting
Problem
Gaps in joints.
V-nails don't drive in all the way in.
V-nail holders won't emerge from V-nail blocks. Soak in solvent to clear away glue or dust. Place a finger under
Moulding joints open up when pressing
V-nails in.
Logan Graphic Products, Inc. ("Logan") warrants the Pro Joiner - Model F300-2, to be free from defects in parts and
workmanship for a period of one year from the date of original purchase. Logan warrants that it will either repair or
replace, at it's sole discretion, any necessary replacement parts found to be defective. Should the product need to be
returned to Logan for repair or replacement parts, authorization for any return must come from Logan in writing.
Costs of returning the product to Logan, including insurances, shall be borne by the purchaser. Logan shall not be
liable for any damages or losses, incidental or consequential, direct or indirect, arising from the use of this product.
This warranty extends only to the original purchaser and is not assignable or transferable. This warranty is in lieu of
7
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 Toll Free 1 800 331 6232 www.logangraphic.com
PRO JOINER
Solution
Sand Mitres smooth.
Make sure the two pairs are equal length.
Reduce the amount of glue in joint.
Check square cutting action of saw.
Use longer V-nails if possible.
Try using one (1) V-nail at a time, especially when joining hard
woods.
Remove any obstruction under vise.
Re-adjust the depth of the lever arm.
V-nail block between block and slider to push V-nail holder up.
Re-adjust the placement of the pressure foot to spread the load
more evenly.
Use one V-nail at a time when foot contacts awkward sloping
profile moulding.
Warranty
all other warranties, expressed or implied.
Model F300-2