Descripción Del Monitor - golmar Platea Uno Manual Del Usario

MONITORS PROGRAMMING
P
rogramming the monitors.
Set to ON the switch number 2 of the configuration dip switch, that's
accessible by opening the terminal connector protection cover
(see door panel instructions manual).
The door panel will reproduce a sound to advise that the system
has entered into programming mode.
In systems with more than one door panel, the programming process
shall be done on the master door panel only.
Switch off the monitor to be programmed, by pressing
the lock release push button during 1 second.
Once the monitor is off, press the autoswitch-on push button.
While pressing the autoswitch-on push button,
press the lock release push button.
To show that the system is ready for programming,
the door panel will reproduce a sound and the picture
will appears on the monitor. At this moment, the
push buttons can be released. Lift the monitor handset.
Each apartment must have one master unit only; in case of parallel units configure them
as slaves, both monitors or telephones.
Make a call to check that the monitor has been succesfully programmed.
Repeat these steps to program the rest of monitors.
Once the programming has been finished, set to OFF the programming
switch. If you don't, the door panel will reproduce a sound to advise
that the system is still into programming mode.
21
Press the door panel push button that will
call to this monitor. At this moment
the door panel and the monitor handset
will reproduce a sound.
To program the monitor as master,
replace the monitor handset.
To program it as slave, press the lock
release push button.
2
DESCRIPCIÓN DEL MONITOR
m
k l
D
escripción de la etiqueta
identificativa.
0000000000
Monitor
Nº serie
Modelo PLATEA Uno
18Vdc ± 2V ATENCIÓN
Alta tensión. No abrir la tapa.
Standby 15mA
Manipular sólo por personal
Máximo 450mA
del servicio técnico.
10ºC + 50ºC
WARNING
High voltage. Don't open cover.
Handle only by technical service.
MASTER SLAVE
INTER A1 ESCALERA PISO PUERTA
Stair Floor Door
CODIGO / CODE
D
escripción del monitor Platea
Monitor Nº serie 0000000000
Modelo PLATEA Uno
g
18Vdc ± 2V ATENCIÓN
Alta tensión. No abrir la tapa.
Standby 15mA
Manipular sólo por personal
a Máximo 450mA
del servicio técnico.
10ºC + 50ºC
WARNING
High voltage. Don't open cover.
h Handle only by technical service.
MASTER SLAVE
ESCALERA PISO PUERTA
INTER A1
b Stair Floor Door
CODIGO / CODE
i
c
d
e
j
f
a. Brazo auricular.
b. Pantalla b/n.
c. Pulsadores no operativos.
d. Indicador luminoso de encendido.
e. Pulsadores de función.
f . Cordón telefónico.
g. Anclajes de sujeción regleta.
h. Etiqueta identificativa.
i . Puntos de conexión regleta.
j . Conector CN2.
k. Conector para cordón.
l . Ajuste de contraste.
m. Ajuste de brillo.
Para facilitar la reparación, sustitución o ampliación
de monitores existentes en una instalación,
complete los datos de la etiqueta identificativa.
MASTER: monitor principal.
SLAVE: monitor secundario.
INTER: función no disponible.
A1: función no disponible.
CODIGO: código del pulsador de llamada (*).
ESCALERA: código del edificio (*).
(*) Ver manual de instrucciones adjunto con la placa.
Uno.