Monitor Description; Descripción De La Regleta - golmar Platea Uno Manual Del Usario

MONITOR DESCRIPTION

F
unction push buttons.
If the handset is on the craddle allows to see the picture from the master door panel.
If not, allows to establish audio and video communication with the door panel
that has been configurated with the autoswitch-on function. This function is
disabled if a communication is already established.
If the handset is on the craddle, press during 1 sec. to switch the monitor on or off.
After any monitor reset and during the next 45 seconds, all the monitor functions
will be disabled, with the exception of call reception.
With the handset lifted, allows to call to the master porter's exchange.
During call reception and communication progresses allows the lock release
activation, with no dependence on the handset position.
H
andling the end of line
jumper.
The end of line jumper is placed on the CN2 connector, that can be
located on the monitor base.
In case of twisted pair cable installations, the end of line jumper
is placed in the EL562 module (see next paragraph).
Do not remove the jumper on monitors where the video cable finish.
Remove the jumper on monitors where the video cable continue.
Locate the CN2 connector, that's placed in the monitor base.
To plug the EL562 module, remove the existing jumper and
the double one (JP1) that's place on the right side.
NOTE: on this type of installations the EL560 module must be
plugged in the door panel microprocessed circuit.
Refer to the specific installation diagram.
19
E
L562 module for video installations
with twisted pair cable.
4
DESCRIPCIÓN DE LA REGLETA
a
b
50mm.
Colocar la parte superior de la regleta a 1,60m. del suelo.
Place the top part of the monitor connector at 1,60m. from the floor.
REF
RCPL-UNO
b
a
a. Orificios de fijación a pared (x4).
b. Pestañas de sujeción del monitor (x2).
c. Entrada de cables vertical.
d. Pestaña de fijación.
e. Entrada de cables central.
f. Terminales de conexión: +, –: positivo, negativo.
Vin / MP: entrada señal de vídeo a través de cable coaxial.
entrada MP señal de vídeo a través de par trenzado.
Malla: malla cable coaxial.
Vo / VP : salida señal de vídeo a través de cable coaxial.
entrada VP señal de vídeo a través de par trenzado.
A : comunicación audio.
D : comunicación digital.
HZ- : entrada pulsador timbre de puerta.
D
escripción de la regleta de
conexión RCPL-Uno.
c
d
50mm.
e
Presionar para abrir.
Press to open.
f
V /MP
in
MALLA
V /VP
o
A
11784082
CODE
D
LOTE
HZ-