How To Install Your Canopy Housing - Rejuvenation Petrel Manual Del Propietário

NOTE: This step is applicable after the necessary wiring
is completed.
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1. Slide the ceiling canopy over the mounting bracket
with the two loosened screws going into the "L" slots
in the canopy. Be sure all wiring is tucked into the
ceiling canopy and is not pinched. Once the canopy
is flush with your ceiling, turn clockwise to seat the
screws into the keyed portion of the slot. Tighten the
screws. (Figure 1)
2. Install the remaining two screws removed in
step 9 of page 8 to secure the ceiling canopy to
the ceiling bracket.
3. Push the canopy trim ring assembly up to
conceal the screws, such that the mounting tabs
seat into the dimpled grooves in the ceiling canopy
midway between the screws.

How to Install Your Canopy Housing

(Figure 2)
(Figure 3)
NOTE: MOTOR WIRES
HAVE BEEN OMITTED
FROM DIAGRAM
Hanger Bracket
Assembly
" L" Slot
NOTE: MOTOR WIRES
HAVE BEEN OMITTED
FROM DIAGRAM
NOTE: MOTOR WIRES
HAVE BEEN OMITTED
FROM DIAGRAM
Canopy
13
Figure 1
Hanger Bracket
Assembly
Figure 2
Canopy Trim
Ring Assembly
Figure 3
Canopy
Mounting
Tabs