How To Assemble Your Ceiling Fan - Rejuvenation Petrel Manual Del Propietário

How to Assemble Your Ceiling Fan

1. Prior to assembly, set aside and save the hardware
bags packed in the packing. Remove the hanger ball
by loosening the setscrew in the hanger ball until the
ball falls freely down the downrod. Remove the pin
from the downrod, then remove the hanger ball.
Retain the pin and hanger ball for reinstallation in
Step 7. (Figure1)
2. Remove the hairpin clip and clevis pin from the
bottom of downrod. Retain the pin and clip for
reinstallation in Step 5. (Figure 2)
3. Remove and discard the three rubber/screws
motor stops from the motor assembly. (Figure 3)
4. Loosen the two set screws and locking nuts in
the downrod support of the motor assembly.
the black/white, blue, red, gray, yellow wires and
safety cable through the downrod. (Figure 4)
5. Slide downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Install the two
set screws with nuts in the downrod support. Securely
tighten the set screws with screwdriver then fully tighten
the nuts by hex wrench. (Figure 5)
WARNING
It is critical that the clevis pin in the downrod
support is properly installed and the set screws
and nuts aresecurely tightened. Failure to do so
could result in the fan falling.
Hanger
Ball
Hairpin Clip
Motor
Assembly
Route
Black/White, Blue, Red,
Gray, Yellow wires
and Safety Cable
Set Screws
and Nuts (2)
Downrod
Hairpin
Clip
7
Pin
Setscrew
Figure 1
Clevis Pin
Figure 2
Motor Stop
Figure 3
Downrod Support
Figure 4
Set Screws
and Nuts (2)
Clevis Pin
Figure 5