Use And Care Information - Faber HILTIS36WHNB Instrucciones De Instalación Información De Uso Y Cuidado

USE AND CARE INFORMATION

For Best Results
Start the Range Hood several minutes before cooking to develop proper airflow. Allow the Range Hood to operate for
several minutes after cooking is complete to clear all smoke and odors from the kitchen.
L
Button Function
Turns the lights on/off at maximum strength.
Press and hold the button for approximately 2 seconds to turn the Dimmer
Lights On/Off.
Turns the motor on/off at speed one.
L
Delay function:
Press and hold the button for approx. 3 seconds to Activate/Deactivate the
Delay function (automatic switching off of the Motor, and the Lighting with a 30
min. delay). Cannot be enabled when Intensive is on.
T1
Turns the Motor on at speed two.
Activate Charcoal Filter Alarm
Press and hold the button for approximately 5 seconds, with all the hood turned
off (Motor and Lights), to turn the alarm on. The relevant LED flashes twice
to confirm. To turn the alarm off, press the button again and hold for at least 5
T2 seconds. The relevant LED flashes once.
Turns the Motor on at speed three.
Grease Filter Alarm
To reset the alarm: press and hold the button for approximately 3 seconds, with
the hood turned off (Motor and Lights), and until the LED S1 flashes three times.
T3
Turns the Motor on at INTENSIVE Speed.
This speed is timed to run for 6 minutes. At the end of this time, the system
returns automatically to the speed that was set before. If it is activated with the
motor turned off, the hood will switch to OFF at the end of the time.
T4
Signals the Metal Grease Filter saturation alarm, indicating that it is necessary
to wash the filters. The alarm is triggered after the Hood has been in operation
for 100 working hours.
When this is activated, it signals:
S1
The Activated Charcoal Filter saturation alarm, indicating that the filter must be
changed;
The Metal Grease Filters must also be washed. The Activated Charcoal Filter
saturation alarm turns on after the Hood has been working for 200 hours.
T1
T1 T2
T2 T3
T3 T4
S1
S1
T4
T2 T3
T3
T4
S1
T4
S1
S1
T4
S1
Led
-
-
ON
ON
ON
ON
ON
Flashing.
29