Craftsman 580.752352 Instrucciones De Uso página 10

,
Before connecting garden hose to water inlet, inspect
inlet screen•Cleanscreen if it contains debris or have it
replaced if damaged•DO NOT run pressure washer if
inlet screenis damagedor missing.
Inspect inlet
screen• DO NOT
use if damaged;
clean if dirty.
4. Run water through garden hose for 30 seconds to flush
it of debris• Turn off water•
IMPORTANT:DO NOTsiphon standing water for the water
supply• UseONLY cold water (less than IO0°F).
5. Connect garden hose (not to exceed 50 feet in length) to
water inlet• Tighten by hand•
NOTICE
Using a OneWay Valve (vacuum breaker or check valve) at
pump inlet can cause pump or inlet connector damage•
ThereMUSTbe at leastten feet of unrestricted gardenhose
between thepressurewasherinletand anydevice,suchas a
vacuumbreakeror checkvalve•
Damage to equipment r esultingfrom failureto followthis
instructionwill voidwarranty•
6. Turn ONwater, point gun in a safe direction and squeeze
trigger to purge pump system of air and impurities•
WARNING
Risk of eye injury•
• _ ISpray can splash back or propel objects•
o lwayswearsafetygoggleswhen usingthis equipment o r in
vicinityof whereequipment i s in use.
. Beforestartingthe pressure washer,be sureyouare wearing
adequate safetygoggles•
ChecklistBefore Starti.g Engine
Reviewthe unit to ensure you have performed all of the
following:
1. Make sure handle is in place and secure•
2. Checkthat oil has been added to proper level in engine
crankcase•
3. Add proper fuel to fuel tank•
4. Checkfor proper hose connections (high pressure and
water supply) and that there are no kinks, cuts, or
damageto the high pressure hose•
5. Provide proper water supply (not to exceed IO0°F).
6. Be sure to read "Safety Rules" and "Operation" sections
before using the cleaning system•
10