Dyna-Glo DGG424CNP Manual Del Usario página 13

ASSEMBLY INSTRUCTIONS
13. Carefully place the firebox assembly (B) onto
the cart left side panel assembly (M) and the
cart right side panel assembly (N). Adjust the
firebox assembly (B) so that the holes in the
firebox assembly (B) are aligned with holes in
the tabs of the cart left side panel assembly (M)
and the cart right side panel assembly (N).
Note: Make sure the gas hose/regulator
assembly is outside the cart. Secure the firebox
assembly (B) with four M6x16 bolts (AA).
Hardware Used
AA M6x16 Bolt
14. Insert two M6x16 bolts (AA) in right side of
the firebox assembly (B) as shown, leaving
5mm of threads exposed. Align key hole in the
right side shelf assembly (K) with the two bolts
just inserted in the firebox assembly (B), and
insert four M6x16 bolts (AA) in the remaining
holes in the firebox assembly (B). Adjust the
firebox assembly (B) correctly, then tighten all
bolts.
Hardware Used
AA M6x16 Bolt
13
x 4
14
x 6
13
AA
AA
AA
AA