Cleaning And Maintenance - Enviracaire Germ-Free EWM-300W Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

USING THE MEDICINE CUP

In order to add a medicated vapor to the "mist" output:

1. Turn the POWER switch to the "OFF" position and allow the steam diffuser to cool.

2. Carefully add liquid medicine to medicine cup. DO NOT fill the cup more than half full.

3. Carefully place medicine cup on top of steam diffuser

4. Turn the POWER switch to either the LO or HI position.

5. After use, remove the cup from the unit and clean any residue from the cup with

warm water.

WARNING:

DO NOT use any liquid medicine other than those specifically recommended for use

with a steam vaporizer or warm mist humidifier.

DO NOT pour medicine directly into the steam diffuser openings nor add it to the

water in the tank or tray.

MINERAL ABSORPTION PAD INSTRUCTIONS

Warm mist humidifiers do not spread fine mineral dust into the air that you breathe

nor on your furniture, the way that other type humidifiers do. The mineral dust remains

trapped in the humidifier hot water reservoir. Use of mineral absorption pads will

play a major role in capturing and removing minerals from hot water reservoir, and

preventing a stubborn mineral buildup. The unit can run without pads, but more

frequent cleaning will be required. The Mineral Absorption pad that fits your unit is the

EMP-15P

1. Before starting humidifier, place mineral absorption pad in the hot water reservoir.

After the humidifier has been operating, the water will become HOT, and CAUTION

should be exercised when handling mineral absorption pad. It is best to allow

humidifier water to cool down, and to use tongs or long tweezers when handling pad.

2. The useful life of the mineral absorption pad will vary, depending on the mineral

content of the water used. In areas of moderate mineral content water supply,

the mineral absorption pad should be changed after approximately (3) weeks

of continuous use. If the water is "Hard Water", the pad should be changed more

frequently. The best way to tell when the pad should be changed is to examine it

AFTER the water has cooled down, to see if it is still soft and pliable. When the pad

is near the end of its life, it becomes stiff and hard and should be replaced with a

new pad. Another sign to change pad is when scale begins to buildup on interior of

hot water reservoir. If pad appears to disintegrate (normally due to use of softened

water) discontinue use of pads.