Troubleshooting - Enviracaire Germ-Free EWM-300W Manual De Instrucciones

STORAGE TIPS
If you do not plan to use your humidifier for an extended period of time, such as during
the summer months, it is important that you follow these instructions to help prevent
problems from developing in the unit.
1. Clean your humidifier as instructed in the section titled, "Cleaning and
Maintenance".
2. Make sure all water is emptied from the tanks and the hot and cold water reservoirs.
3. Dry your unit thoroughly.
4. Leave the tank caps off to expose the tanks to air.
5. Pack your humidifier in its original carton and store it in a cool, dry place.
SERVICE
DO NOT attempt to repair this humidifier yourself. For repairs covered under the
warranty, contact Kaz Incorporated by telephone or mail for a Return Authorization
Number.

TROUBLESHOOTING

TROUBLE
Unit does not mist
Water leaks from unit
Moist air output low
Refill indicator light on
EWM-300W-350_OM.indd 9
POSSIBLE CAUSES
Unit is not plugged in
Power failure
Water tanks empty
Power switch not turned on
Unit not reset after refilling tanks Reposition water tanks
Water tank not properly
located on base unit
Humidity level set is achieved
Using distilled or treated water
which does not contain
enough ions
Only one tank empties
Tank cap or tank cap
gasket is missing or improperly
positioned
Mineral buildup in hot water
reservoir
Water level is below water
level probes
Water level probes
are covered with film
Mineral buildup in hot water
reservoir
SOLUTION
Plug in unit
Check circuit breaker
Remove and refill
Turn on switch to LO or HI
Reposition water tanks
Turn Relative Humidity
Control to higher setting
Add "pinch" of table salt
Move unit to level surface.
Raise end with full tank.
Tighten cap.
Replace tank cap
or reposition cap
gasket.
Clean unit as per
instructions.
Refill water tanks
and mount tanks on base
Clean probes per
cleaning instructions
Clean unit per
cleaning instructions
3/26/07 2:58:04 PM