X-LITE X-702 GT Seguridad E Instrucciones página 16

VPS DISASSEMBLY INSTRUCTIONS
1.1 To disassemble the VPS, open the helmet visor and make sure the side slider is in dow-
nward position (Fig. 10 B).
1.2 Hold the left part of the VPS and pull it outwards until the grip pawl is removed from the
VPS mechanism (Fig. 11).
1.3 Repeat the same steps on the right side of the VPS and remove it.
VPS ASSEMBLY INSTRUCTIONS
2.1 To assemble the VPS, open the helmet visor and make sure the side slider is in upward
position (Fig. 10 A).
2.2 Insert the left end of the VPS into the left side guide until the grip pawl is hooked in the
mechanism (Fig. 11).
2.3 Repeat the same steps on the right side.
2.4 Check the correct VPS operation by moving the left side slider downwards (Fig. 10 B)
and upwards (Fig. 10 A) until you hear the clicks meaning that it is in the relevant posi-
tions. If necessary, repeat the above-mentioned steps.
- If the visor and/or VPS opening/closing mechanisms are damaged or malfunctioning,
please contact an X-lite authorized dealer.
- Do not use the helmet if the VPS has not been assembled properly.
WARNING!!!
The VPS does not replace the protection guaranteed by the visor.
•
(Available as an optional accessory)
1 PINLOCK ® INNER VISOR ASSEMBLY
1.1 Remove the visor.
1.2 Make sure that the inner surface of the visor is clean and check that the pin adjustment
external levers are turned inwards.
1.3 Place the Pinlock
Pinlock ® inner visor should be in contact with the inner surface of the visor.
1.4 Fasten one side of the Pinlock
tion (Fig. 12).
1.5 Widen the visor and fasten the other side of the Pinlock
(Fig. 13).
1.6 Release the visor.
1.7 Remove the protective film from the Pinlock
ne-sealed profile of the inner visor adheres to the visor.
1.8 Fit the visor in the helmet.
CHECKING AND ADJUSTING THE INNER VISOR STRETCHING
Check the correct system assembly by opening and closing the visor. Check that both visors
are correctly fastened and do not move.
If the inner visor is not tightly fixed to the visor, move the external adjustment levers simulta-
neously upwards to increase the stretch (Fig. 14). This operation must be carried out gradual-
ly. The maximum stretch is achieved when the pin adjustment external levers are turned out-
wards.
WARNING!!!
The presence of dust between the two visors may produce scratches on both surfaces.
Scratched visors and inner visors may cause reduced visibility and must therefore be replaced.
Regularly check the correct stretching of the inner visor to prevent the same from moving and
scratching both surfaces.
If the helmet visor fogs up and/or condensation forms between the visors, check both for
system correct assembly and stretching.
® inner visor on the visor. WARNING: The silicone-sealed profile of the
® inner visor to one of the visor pins and hold it in posi-
® inner visor to the second pin
® inner visor and check that the entire silico-
16