ZUMEX Soul 2 Serie Manual De Instrucciones página 12

Easy to clean,
like everything in Soul
Disconnect the machine from the mains and remove any obstacles from
1
around the machine.
2 Raise the Front door up with your hand as far as it will go.
To close it, gently move it down with your hand until you hear a slight click.
Important! For safety reasons, the machine will not start up unless the
door is fully closed.
The Case Out is removed in two steps:
3
1. Hold of the Front handle (A) and pull it carefully outwards, sliding it
along the guides until the Case Out reaches the end of the guides in the
front area.
2. Hold the Side handles (B) of the Case Out in your hands, gently
lifting it over the front stops, and pull it out, sliding it along the guides
(C). Carry the unit in the same position to prevent dripping. To put it
back in the machine, take hold of it by the handles with both hands,
take the two guides at the left and right of the machine interior as your
reference, and insert the unit inwards as far as it will go.
Carefully support the Case Out on a flat surface to disassemble it, resting
it on its left face and leaving the latches on that side. Open the four latches
4
to disassemble the Feeder Case.
5
Pull the Case upwards.
Remove the two peel ejectors, left and right, from the Feeder Case for
6
subsequent cleaning.
1 2
4 5
EN 22
3
C
A
6