Description; Prior To Use; Important; Setting The Clock - Krups KM730 Manual Del Usuario

KR_CAFETIERE_KM730_NC00116597_Mise en page 1 06/11/12 12:00 Page7

2. DESCRIPTION

a Main body
b Top lid
c Water tank
d Water level indicator
e Carafe lid
f Carafe handle
g Carafe
h Heating plate
i Filter holder

3. PRIOR TO USE

Operate your coffee maker for the first time without coffee using 1 liter of water to rinse the circuit.
IMPORTANT: Use only cold water. The automatic brewing system has been
designed to work only with cold water.

4. SETTING THE CLOCK

There are two ways to set the clock on your coffee maker.
1- When you initially plug in the coffee maker, the unit will beep and "12:00" will flash on the LCD display
for a few seconds. Press immediately the h/min button (o) to set the current hour. If "12:00" starts to
flash, press the PROG button (n) for a few seconds until the "12:00" flashes again. Then press the
h/min button (o) to set the current hour. There are AM and PM indicators on the top right side of the
LCD screen. To set the current minutes, press the PROG button (n) and then press the h/min button
(o) until the correct minutes appear on the LCD display. After 5 seconds, the unit will beep and the
time will stop flashing.
2- At any other time, you can set the clock or change the set time by pressing and holding the h/min button
(o). The unit will beep and "12:00" will flash on the LCD display. Use the h/min button (o) to set the
current hour. There are AM and PM indicators on the top right side of the LCD screen.
To set the current minutes, press the PROG button (n) and then press the h/min button (o) until the
correct minutes appear on the LCD display. After 5 seconds, the unit will beep and the time will stop
flashing.
Notes: Your clock has now been set and will continue to keep the correct time, even after the coffee
maker has been shut off.
Unplugging the coffee maker or a power failure will reset the clock to 12:00 AM. Repeat the instructions
above to reset the clock.

5. MAKING COFFEE

1- Open the coffee maker lid (b).
2- Place the coffee maker on a hard, flat surface. With the coffeemaker turned off, plug into a 120V outlet.
3- Fill the carafe with fresh, cold water (preferably bottled or filtered water). Open the hinged cover and
pour the water into the water tank Fig. 1 and 2. The number of cups is shown by the water level
indicator Fig. 3. Do not exceed the 12 cup level.
j
Permanent filter
k On/Off button with blue LED
l Auto On brewing selection button with blue LED
m Aroma coffee selection button with blue LED
n Programming button with blue LED
o h/min button with blue LED
p Display
q Spoon
English
7