Supply Dispenser; Cycle Selection; Cycle Execution - Alliance Laundry Systems S Serie Instrucciones De Funcionamiento Y Programacion

CAUTION
Check the door safety interlock daily before
the machine is placed in operation.
Note: When washing items which may
disintegrate or fragment, such as mop heads
or sponges, use laundry nets to prevent
drain blockage.

Supply Dispenser

Supplies are placed in the supply dispenser
compartment cups prior to the start of
each cycle.
Liquid supplies can be injected directly into
the supply dispenser by an external chemical
supply system.
Note: Supply dispenser compartment cups
must not be removed when an external
chemical injection supply system is attached to
the washer-extractor.
Note: External supply signal 5 is energized
and supply dispenser compartment 5 flushes
whenever a Supply 4 or Supply 7 (Supply 3
and Supply 4 combined) is called for in a
program segment.
F232087

Cycle Selection

Note: Press keys at their centers just hard
enough to activate them.
SW024
Press the Up or Down key until the desired
cycle number is displayed. Press the Start
key to start the cycle. For a more detailed
description of the preprogrammed cycles,
see the cycle charts at the end of the
Programming section.
If the computer detects that the door is not
properly closed when the Start key is pressed,
the display will read "door" until the door is
closed and locked. Press the Start key again to
begin the desired cycle.

Cycle Execution

A cycle can be stopped at any time by pressing
the Stop key. The machine will go to the stop
routine. When the routine is complete, the door
may be unlocked.
To display the temperature of the water while a
cycle is running, press the Up key. To display
the number of the cycle in progress, press the
Start key.
Operation
17