Alliance Laundry Systems S Serie Instrucciones De Funcionamiento Y Programacion página 27

9. Use the Up or Down key to select the
desired supply option. See the table below.
Supply Options
Display
SUP0
SUP1
SUP2
SUP3
SUP4
SUP5
SUP6
SUP7
*This is available only if supply 4 is enabled.
Note: External supply signal 5 is energized
and supply dispenser compartment 5 flushes
whenever a Supply 4 or Supply 7 (Supply 3
and Supply 4 combined) is called for in a
program segment.
10. Press the Start key.
11. If the machine is equipped with an
auxiliary heating system and the
corresponding SETUP option is enabled,
use the Up or Down key to select the
desired segment temperature. To disable
auxiliary heat for this segment, set this
value to zero.
F232087
Supply
No Supply
Supply 1
Supply 2
Supply 3
Supply 4*
Supply 1 and 2
Supply 2 and 3
Supply 3 and 4*
Programming
Note: Do not program heat steps for machines
not equipped with auxiliary heat. The machine
will pause for 30 minutes during any step in
which the fill water temperature does not
already equal or exceed the programmed value
of the heat step.
Note: Do not program auxiliary heat in a
prewash segment containing a flush step.
12. Press the Start key.
13. Use the Up or Down key to select the
desired spin time. Set this value to zero to
skip the spin step. Press the Start key. The
display will now show the identifier for the
next program segment.
Note: An automatic 40-second coast-down
follows every high-speed spin. For all spins
except the final spin, this coast-down occurs
during the fill for the following segment.
Therefore, cycle time is not increased for
coast-downs following all but the final spin.
14. Press the Stop key at any time to complete
the cycle programming procedure.
25