Care And Maintenance - Master Forge RT2417S Manual Del Usuario

CARE AND MAINTENANCE

Checking the Flame
Refer to Fig. 29 below (side view of grill). Check the flame after the grill is lit. Make sure you
have a stable, mostly blue flame.
Air Shutter Adjustment
The main burner shutters are adjusted at the factory for your convenience. The settings are:
(1) Full open for LP gas.
(2) Half open for NG gas.
If you desire to fine tune your shutter adjustment (or if your flame is more yellow rather than
blue), please follow this procedure.
WARNING: Do not touch burner after adjustments. The burner is hot.
a. Loosen the air shutter. The shutters are located on the end of the gas burners underneath the
control box. See Fig. 30
b. Loosen the air shutter screw.
c. Light the burner to be adjusted.
d. With a protected gloved hand, fine tune the air shutter until a stable, mostly blue flame is observed
through the flame observation hole and slots on each side of the burner box. Acceptable flames
are shown in Fig. 31
e. Tighten the air shutter locking screw enough to hole the shutter in place.
f. Repeat procedure on other burners.
Fig. 30 Air Shutter
Flame Observation Hole
Air Shutter
30
(a)
(b)
(c)
Fig. 31 Acceptable Flame (only a)
Lowes.com/masterforge
Fig. 29
√
×
×