Important - Bunn MY CAFÉ Manual De Uso Y Cuidado

:
My Café has an internal hot water tank that must be filled with water before brewing.

important

Fill the Pour-in Bowl and run 2-3 brew cycles. The machine will begin to heat and be ready to brew.
1. Plug in brewer. The Brew Button will
flash red, indicating that water is needed
and the brewer is ready for set-up.
2. Position cup (14 oz. or larger) on
Drip Tray under Pod Drawer.
Do not brew directly into untempered
glass or plastic cups/glasses. Use only
heat-resistant vessels.
3. Place empty Pod Drawer into
Drawer Guides and push in to
lock into place. The Pod Drawer must
be locked into place before brewer
will operate.
4. Fill a container with 14 oz. of
cold water.
5. Open Spin Lid on top of brewer.
6. Fill Pour-in Bowl with water.
Your My Café is now heating the water. Wait 2 to 3 minutes for the indicator light to turn
from red to green. You are now ready to brew!
SETTING UP
MY CAFÉ SINGLE SERVE POD BREWER
®
7. Close Spin Lid.
8. Push Brew Button. Wait approximately
two minutes for the internal hot water
tank to partially fill with water. You may
hear some squeaking as the pump primes.
This is perfectly normal and will only occur
during setup.
9. Empty cup if any water is present,
then place cup on Drip Tray under
Pod Drawer.
10. Repeat steps 4 through 7.
11. Push Brew Button. Wait about
2 minutes for internal hot water tank
to finish filling with water. Excess water
will fill the cup. If the Brew Button is still
flashing red, repeat steps 4 through 7
and push Brew Button again.
3