Kolcraft Contours Options Hoja De Instrucciones página 13

To Install and Use Infant Car Seat Adapter
Restraint Bag
2
Black
Restraint Bag
Bumpers
To Secure All Acceptable Infant Car Seats
1 & 2
3
Belt Slots
3
Lowest Center Point
Front Bar
Side Rail
Slot
13
To remove seat, push in release levers
1
located underneath handles and lift up.
Align Infant Car Seat Adapter as shown
2
with the black bumpers toward the back
of the frame.
Push adapter into side rail slots until a
3
click is heard on both sides. Pull up on
adapter to make sure it is secured to the
frame.
WARNING
When using this product, to avoid seri-
ous injury from falling or sliding out,
infant must always be secured in the
Infant Car Seat with the Car Seat har-
ness. Refer to Infant Car Seat
Instructions for proper adjustment.
With one hand, grasp the Infant Car Seat
1
handle (in its upright, carrying position).
With your other hand, grasp Infant Car
Seat near baby's feet. Gently position the
Infant Car Seat above Infant Car Seat
Adapter so the baby faces the stroller
handle.
Lower the Infant Car Seat between
2
the front & rear bars. Remove restraint
buckles from bag.
For a secure fit, wrap restraint straps
3
through Infant Car Seat belt slots and
buckle. Tighten Restraint Straps. Special
Instructions for Car Seats without belt
slots: Secure Infant Car Seat to Adapter
by wrapping restraint over seats lowest
center point near handle and buckle them
together. Tighten Restraint Straps.
NOTE: Shopping cart lever will not lock
onto the carrier. To secure infant car seat
to carrier, use restraint straps.