Alcad SCM-030 Guia De Inicio Rapido página 9

V I D E O P O R T E R O D I G I TA L - D I G I TA L V I D E O D O O R E N T R Y S Y S T E M S - V I D É O P O R T I E R N U M É R I Q U E
PASOS PROGRAMACIÓN
1
2
3
4
5
6
Nota :
PROGRAMMING STEPS
1 Connect the monitor connector to the connection bracket.
2 Connect the cord between the monitor base and the receiver. You will hear a continuous tone with the PROG switch in the ON
position.
3 Turn the PROG switch to the OFF position (3.1), the tone stops. Turn the switch back to the ON position (3.2).
4 Press the lock release button. The audio and the video will be activated between the monitor and the main panel. The monitor is
ready to receive the code. The connection bracket has been programed.
5 From the main entrance panel, make the call to the house or flat when monitor to be programmed is installed. The
panel emits a confirmation tone. The connection bracket has been programed.
6 Check the operation of the monitor (call, audio and door opening). If the monitor does not function correctly then repeat the process
from Step 3.
Note: Maximum time limit of 1 minute between Steps 3 and 4 and between 4 and 5. The system warns by means of a series of beeps
of the end of the time limit between Steps 4 and 5; repeat Step 4 to have another minute. If the time limit is exceeded the process must
be repeated from Step 3.
ETAPES DE PROGRAMMATION
1
2
3
4
5
6
Remarque: