Ansel 2615 Guía De Usuario página 58

the IP address for your PCs.
Configure the IP address manually
1) Set up the TCP/IP Protocol for your PC(s). If you need instructions as to how to do this.
2) Configure the network parameters. The IP address is 192.168.1.xxx ("xxx" is from 2
to 254),
192.168.1.1(The router's default IP address)
Obtain an IP address automatically
1) Set up the TCP/IP Protocol in "Obtain an IP address automatically" mode on your
PC(s). If you need instructions as to how to do this,
2) Power off the router and PC(s). Then turn on the router, and restart the PC(s). The
built-in DHCP server will assign IP addresses for the PC(s).
Go to Start, Run, type command (for Windows 95/98/ME) or cmd (for Windows2000/XP) and
click OK. You will see the command prompt as below.
Open a command prompt, and type ping 192.168.1.1, then press Enter. You should get four
reply responses back.
If the result displayed is similar to that shown in the top of figure, the connection between
your PC and the router has been established.
Subnet Mask is 255.255.255.0, and Gateway is
58