( 1LH ) Luxur y-Lift
®
Batter y Backup Assembly Instructions:
WARNING
-- To reduce the risk of serious injury:
•
In the event of a power failure the batter y backup provided may not
lift the user to a fully raised position.
•
In the event of a power failure, if you require a lift to the fully raised
position or multiple lifts and recline, a batter y backup system may be
purchased separately. Contact your La-Z-Boy
•
Replace the Power Transformer batteries ever y six months and after
each power failure use.
Batter y Backup Assembly Instructions
In the event of a power failure the batter y backup should return the user to the
seated position from a fully raised position or a full recline position, one time.
The Batter y Backup is located in the Power Transformer and uses two 9-volt
alkaline batteries (not included).
1. Unplug the Power Transformer from the electrical outlet.
2. Remove the (2) Phillips head screws from the batter y cover on top of the
Power Transformer.
3. Place the connection caps over the batter y terminals on each batter y.
Place the batteries in the Power Transformer (F
4. Place the batter y cover over the batteries and secure with the two Phillips
head screws removed in Step 2 (F
5. Proceed to the Luxur y-Lift Power Recliner with Heat Operating Instructions.
F
1
IGURE
22
Power Recliner with Heat
®
dealer for more information.
1).
IGURE
2).
IGURE
F
2
IGURE
(2) 9-Volt
Alkaline
Batteries
Power
Transformer
Battery
Cover
( 1LH ) Luxur y-Lift
®
Power Recliner with Heat
Operating Instructions:
DANGER
-- To reduce the risk of serious injury or death:
•
Do not let children play on or near the chair when in use. Serious injury or death
could occur if a child is under the chair when the chair is moved from the full lift
to the seated position.
•
Plug directly into a wall outlet. Do not use an extension cord or adapter.
WARNING
-- To reduce the risk of serious injury or death:
•
The 1LH lift chair is intended for a single occupant, not exceeding 500
pounds. Do not operate the chair with more than one occupant in or
the chair.
•
Sit down in the unit slowly. To avoid tip over, do not throw your weight
against the back of the unit. Move the unit into or out of the reclining
position slowly, making sure that no children or pets are in close proximity.
•
To safely exit the unit and prevent a tripping hazard bring the back
upright and close the legrest.
NOTICE:
To prevent product damage:
•
Operate this chair only when it is upright, setting on its base.
•
Operating the UP and DOWN function continuously may cause the
power transformer to fail, or may cause the motor to overheat and
shutdown. Allow several minutes between each UP and DOWN cycle.
Plug in the Power Transformer. Make sure there is enough slack in the cord
running from the chair to the outlet to allow for lifting and reclining. Never
stretch or strain a cord.
Luxur y-Lift
®
Power Recliner Operation
The hand wand is located in the pocket of the right side sitting arm.
•
Stand beside the chair, press and hold the toggle switch UP on the hand
wand to raise the chair. Release the toggle switch when the chair
reaches a comfortable height to sit against.
•
Step back into the chair and lean against the seat. Press and hold the
toggle switch DOWN to lower the chair. Release the toggle switch when
you reach the seated position.
•
To recline press and hold the toggle switch DOWN. Release the toggle
switch when you reach the desired recline position.
•
To return to the seated position press and hold the toggle switch UP.
Release the toggle switch when you reach the seated position.
•
To raise the chair to a standing position press and hold the toggle
switch UP. Gradually shift your weight forward as the chair rises.Release
the toggle switch when the chair reaches a height that enables you to
easily stand.
(Operating Instructions Continued)
23