( 01L ) Luxur y-Lift
Assembly Instructions:
WARNING
- - To reduce the risk of injur y:
•
Do not operate the unit until the back is installed and locked.
1. Install the back.
•
Lay the back across the arms of the body. Lift the back at a slight angle
and align the brackets on the back with the brackets on the body (F
•
Lower the back onto the body, making sure the back and body brackets
are completely engaged.
•
To make sure the back is properly installed with both sets of back and
body brackets engaged, stand behind the chair and twist the back from
side to side. If one or both sides move out of position the brackets are
not engaged (F
2). Remove the back and repeat the steps above.
IGURE
•
If you are unable to install the back properly contact your La-Z-Boy
dealer for assistance.
•
Lock the brackets by using a screwdriver to push down the locking levers
(F
3).
IGURE
WARNING
- To reduce the risk of serious injur y:
•
Check the condition of the power transformers, electrical cords, plugs
and connectors monthly. Keep the power transformer and electrical
cords away from heat sources. Never operate the unit with a damaged
power transformer, electrical cord, plug or connector. Contact your
La-Z-Boy
®
dealer for ser vice.
NOTICE:
Do not plug the transformer in until instructed.
2. Locate and connect the Power Transformer.
•
Locate the Power Transformer secured to the rear rail. Carefully cut the
cable tie and remove the Power Transformer from the rear rail. Remove
the packing and unwind the cord.
•
Locate the Motor Extension Wire attached to the rear of the motor
(F
4). Carefully cut the cable tie and unwind the cord.
IGURE
•
Align the white dot on the Power Transformer connector with the arrow
on the Motor Extension connector (F
until they are secured, with no gaps between them.
3. Attach the outside back upholster y cover.
•
Pull the outside back upholster y cover down tight. Firmly press the
fastening tape on the outside back upholster y cover to the fastening
tape on the bottom of the rear rail.
WARNING
- To reduce the risk of serious injur y:
•
Provide a clear path for operation of the chair, back and legrest.
Place tables and area rugs at a distance to allow the legrest to fully
extend without rubbing or interference.
4. Choose a location for the chair that is close to an electrical outlet and
proceed to the Operating Instructions.
6
®
Power Recliner
1).
IGURE
®
5). Push the connectors together
IGURE
( 01L ) Luxur y-Lift
Assembly Details:
F
1
IGURE
Body
Bracket
Back Bracket
F
3
IGURE
Back
Bracket
Locking
Lever
Locked
Position
F
5
IGURE
®
Power Recliner
F
2
IGURE
Back and body brackets on this side are not
engaged. Remove the back and reinstall.
F
4
IGURE
Motor
Extension
Connector
Power
Transformer
Connector
Rear
Rail
Motor
Extension
Wire
7